You need to remove the inner part of the glove box.. you will see two screws in the compartment that the insert covered. Next take off the trim around the instrument cluster by removing the screws on the top of it that secures it to the top dash pad... remove the molding.. there will be two screws under that, one being to the right of the radio,, the other about the same to the left.. The there are two screw in the defroster molding that need to be removed... Pull out the top dash about half an inch and then pull up and remove it.... Then you can remove the speakers and the replace them if you wish.......
Front = 3 & half, Rear = 4x10
Take it to Best Buy and have them switch out the speakers. That's what I did.
You must first remove the instrument panel,then remove all the screws that hold the top of the das on, then you will see you speakers. It is a lot to go threw, but i just did mine and it worked out ok. Cheers
If you have never done one before. Don't without the correct manual in front of you.
how do i remove the front fender to 1996 Oldsmobile cutlas supreme.
Which speakers are you trying to replace? Front or rear?
HogDog says 3.5 W 1.5 D/Total 2-3/8 W/Magnet 5/8" thick
I have 2 of these cieras and NO they are front wheel drive, the cutlass supreme is real wheel drive
I have a 1982 cutlass supreme and the diagram in under the hood on a front panel, If not someone may have removed it.
If it is the 3.4L Twin DOHC version, it is a monstor job. This motor has timing belt and timing chain. The entire front cover of the engine has to come off to replace both.
how change front strut on1995 Oldsmobile catlass suprime
The 1996 Oldsmobile Cutlass Supreme temperature sending unit can be found on the front of the engine. The temperature sending unit will be a few inches above the thermostat housing.