89 polairis 300 exploer 4 wheeler front sproket
it is a 300 polaris explorer
YOu need to remove both CV joints. after that the shaft on which the front sprocket rides will come out of the front diff. Just hit it back with a rubber mallet and put your new sprocket in place then hit from the other side to run the shaft through the sprocket. Reassemble. The front 'axle' or diff is held in by the chassis metal being bent around it. it is not removable.
It depends on whether you are talking about the front sprocket (the one at the pedals, called a chainring) or the sprocket at the rear derailleur. The lowest gear at the front is the smallest sprocket/chainring. The lowest gear at the rear is the largest sprocket. So if you combine the smallest sprocket at the front with the largest sprocket in the rear you have the lowest gear available on your bike.
Here's the setup on my 2007 polaris predator 500. -Trinity Racing Stage IV full exhaust -170 jets -K&N air filter -Moose 15 tooth front sprocket. hope this helps.
How do you remove the front sprocket from Honda trx 250r
Under the timing belt sprocket, on the front of the crankshaft.Under the timing belt sprocket, on the front of the crankshaft.
Yes it does. It is near the front sprocket at the back of the engine. Look for a yellow dipstick. You will need to get Amsoil severe gear synthetic oil 75/90w at NAPA or your Polaris dealer will have the oil. I have yet figured out how to drain it.
A bigger front sprocket gives a higher top speed. A bigger rear sprocket gives a lower top speed. A bigger front sprocket is less torque more top speed, and a bigger rear sprocket is more torque less top speed.
how do i change front brake pads on my 2002 polaris 500 sportsman
You DO NOT adjust those...if you a lot of bounce or bottoming out STOP the jumping of the bike and replace the struts
No way of telling, it depends on how strong or high revving the engine is. Switching to a bigger front sprocket might make the bike faster, but only if the engine is strong enough.
115nm