0
How do you replace harmonic balancer in a 1990 Oldsmobile 98 regency broughm?
Wiki User
∙ 14y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you change the harmonic balancer for 1989 ninety eight Oldsmobile regency?
take off the right wheel and the cover wall and you wll see it
How do you replace a Crank Position Sensor on a 1992 Oldsmobile Regency 98?
It takes a special tool. I got mine from Autozone and had a guide from them on how to replace it. You'll have to remove the belt and harmonic balancer and access it through the passanger side front tire.
Where is gas filterin your 1985 Oldsmobile regency?
where is gas filter location in 1985 oldsmobile regency
How do you replace a wheel berring on an Oldsmobile regency 98?
how do you replace a wheel bearing on an 1985 oldsmobile regency 98
How do remove and replace the ignition switch of a 1983 Oldsmobile Regency?
How do remove and replace the ignition switch of a 1983 Oldsmobile Regency?
How do you replace a wheel berring on an 1985 Oldsmobile regency 98?
how do you replace a wheel bearing on an 1985 oldsmobile regency 98
How do you change a crankshaft position sensor in a 1997 Oldsmobile Regency?
1. remove positive battery cable. 2. Remove the serpentine belt. 3. remove harmonic balancer. 4. remove timing cover. 5. remove wiring connector from c.p. senser. 6. remove c.p. senser. 7. reassemble in same order as disassembled.
Where is cam sensor on 92 Oldsmobile 98 regency?
passengers side behind harmonic balance pulley bottom of engine.Put on lift take off tire makes job easier
How much does a 1991 Oldsmobile ninety eight regency elite sedan weigh?
how much does a 1991 oldsmobile regency elite weigh
How do you find a crankshaft sensor on an Oldsmobile ninety eight?
DEPENDS ON WHAT MOTOR YOU HAVE,BUT IF ITS A 3800 ITS RIGHT BEHIND THE BALANCER.MUST REMOVE THE BALANCER, THAN UNBOLT SENSOR BE SURE THAT WHEN YOU INSTALL IT... THAT THE RING ON THE BALANCER DOES NOT HIT THE SENSOR OUR YOU WILL BE DOING IT AGAIN. I got stuck at the harmonic balancer because on my 1996 98 regency elite it seems you have to take the engine mount bracket off because, one of the arms to the bracket is secured over the top of the sensor to the engine block maybe this will help someone avoid alot of work they might not be able to handle lol
What is the weight for a 1985 Oldsmobile regency?
The curb weight for a 1985 Oldsmobile Regency is approximately 3,500 pounds. This weight does not include any modifications made to the vehicle.
Where is the ecm located on a 1993 Oldsmobile regency 98?
ecm location 93 oldsmobile 98
