Weekend project.
Pull the intake manifold off and the throat assy. Pull the radiator cover and all the front pieces so you have access to the timing belt. Loosen this and remove the belt. The internal areas are now open to the heads. Disconnect the exhaust manifold from both sides and see if you can get the bolts off from the head. This allows the manifold to lower just enough to get the head off. Now remove all the extra things tied to the head, like spark plug wires and such. Unbolt the head and remove it from the vehicle. If you couldn't remove the bolts from the exhaust then remove the exhaust manifold from the exhaust pipe. Now lift the whole thing out. At some point you should be able to remove the head. Clean and replace the gasket and then put it all back together. Piece of cake huh?
Get yourself a manual and it will lead you step by step. I can do mine in a weekend but I have doen lots of repairs on it so I don't even think about it anymore. Except to ensure I am putting it together correctly.
http://www.atarmor.com/3rdmemwriteup/writeup2.htm
How do you bleed the heater after changing coolant in a 1992 4runner
5,000 lbs. is what I saw
The intake air temperature sensor on a 1992 Toyota 4Runner will be found on the intake system. The unit is clipped into the plastic piping of the intake.
10w 30
Where is the thermostat located and how do you replace it on 1992 toyota camry 4 cylinder ingine
How do i replace speed sensor on 1992 toyota previa and where is the sensor located
The fuel filter 4runner v6 sr5 is located under the car, underneath the the front passenger seat behind the chassis..
Your 1992 Toyota transmission will hold 12 quarts of transmission fluid, when it is empty. You can check the transmission fluid level with the dipstick.
Do you still need some assistance?
If it's a 1992 V6 4Runner with an automatic transmission, the three wire speed sensor for the speedometer is located on the extension housing of the transmission.
The most expensive part of a clutch job in your Toyota will be (as it always is) the labor; 5 to 6 hundred dollars. The clutch assembly is about 450.00$. There may be incidentals added to this, so bank on about 1,000.00$. I have a 1991 4runner with 312 thousand kiometres on the original clutch. Try to find that on any other model, North American or other.
how do you install a water pump on a 1992 toyota camry