answersLogoWhite
Car Computers and Sensors
Toyota Previa

How do you replace speed sensor on 1992 Toyota Previa and where is the sensor located?

123

Top Answer
User Avatar
Wiki User
2012-01-26 08:45:59
2012-01-26 08:45:59

How do i replace speed sensor on 1992 toyota previa and where is the sensor located

1

Related Questions

User Avatar

Knock Sensor On your 1992 Toyota Truck Previa 2WD (2.4L FI DOHC), the Knock Sensor is located: Front seating area, center, under engine cover, passenger side of engine, under intake manifold, mounted in engine block

User Avatar

01 toyota salara oxygen sensor how to replace it code p1135 p1155

User Avatar

where is the speed sensor located on 2003 Toyota matrix

User Avatar

Try and get someone to read the ECU codes, that will tell you if the problem is from the "Knock Sensor". If it is you will need to buy a new one and replace it. They are very expensive and can only be got from a Toyota Dealer. To fit your self Drill a hole under the front seat(Directly above the sensor) and replace from there. If you dont want to drill a hole you will have to drop the engine and that is not a cheap option on a previa.

User Avatar

The coolant temperature sensor can be found on the front of the engine, near the thermostat. Remove the coolant temperature sensor retaining nut, to replace it.

User Avatar

under the throttle body. Has a green sensor attached to it. Can't miss it.

User Avatar

The air flow sensor is located inside the air box of a 1998 Toyota Camry LE. To replace the unit the air box screws must be unmounted and the sensor disconnected.

User Avatar

The MAP sensor is located on the engine compartment on 1988 Toyota Corolla. The MAP sensor can be purchased at any auto parts store.

User Avatar

labor cost to change an oxygen sensor in a 1995 toyota avalon

User Avatar

Where is the oxygen sensor code p1155 located in toyota mini van sienna?

User Avatar

The 1988 Toyota oxygen sensor is located on the air cleaner housing. You will find the sensor, on the back side of the housing.

User Avatar

The IAT for the Toyota 4 Runner is located with the vafm wiring. The sensor should be located there, as well.?æ

User Avatar

The coolant temperature sensor on a 2001 Toyota RAV4 is located on the exhaust manifold. It is on the driver's side of the manifold.

User Avatar

The 2006 Toyota coolant temperature sensor is located on the front of the engine. The coolant temperature sensor will be a few inches above the thermostat housing.

User Avatar

where is the crank sensor for 1994 toyota corolla 1.6 ltr

User Avatar

The map sensor comes standard on a 1998 Toyota Rav4. It is typically located on the dashboard panel on the drivers side of the car.

User Avatar

First - Make sure the sensor is a genuine Toyota replacement part. There a clip fitment at the bank - use a screw driver to release the fitment. Use small rench at the bottom of the wire to release the sensor. Replace and Start. Run for few minutes and rev the engine until warm/hot. Lights will go off OR resent the code.

User Avatar

HERE IS THE LOCATION ,USE A SPANNER TO REPLACE IT. https://sites.google.com/site/autobestanswer/toyota

User Avatar

the temperature sensor on the 1995 Toyota Tacoma is located on top of the engine on the front. It is beside of the thermostat housing and screws into the intake.

User Avatar

You can not replace just the tire pressure sensor on a Boxster. You will need to replace the whole sensor. The sensor is located inside the tire assembly.

User Avatar

the knock sensor is located on the driver side of the engine right under the intake it is about 1 in. it is connected so you will have to unplug it and then just screw it off

User Avatar

its is located downstream on the backside exhaust manifold


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.