Want this question answered?
in the center console, under the Radio
If I'm not mistaken you should have sealed beam headlights as mine does. If you are getting water into a sealed beam headlight you will have to replace the lamp. The old one is no longer sealed.
To change the headlight on a 1985 Honda Spree scooter remove the headlight housing. The scooter headlight will be mounting on the rear of the housing. Remove it and replace the bulb.
You need to replace the entire headlight. Only remove the screws that hold the trim in place. Don't back out the adjustment screws.
Replace the slow headlight motor.
Where is starter relay on a 1986 volvo 240gl
Not removable- replace entire hinge assembly
You must stop the headlight in the up position. Sometimes you have to do this manually, with the over-ride on the headlamp motor.It's best to do this with the hood up. There are two screws in front of the headlamp on the bottom that must be removed. Then turn the assembly to the partially down position to remove two more screws; one on either side toward the rear of the assembly. This will enable you to remove the cover. Then simply remove the screws that hold the chrome frame around the bulb and replace. Reverse procedure for install. CAUTION: be sure not to mistake the adjustment screws for the retaining screws, as your headlamps will be out of allignment. when the headlight is up..or {on position}..it can be changed.. !!!!
To replace a tail light bulb in a 1986 to 1989 Chevy Celebrity: 1. Inside the trunk next to the quarter panel there are 3 nuts that hold the rear header on. The middle bolt holds the tail light assembly on, take it off. 2. Pull the tail light assembly out enough for the stud to clear the body then pull to the side to pull the tabs out of the backup light assembly. 3. Give a slight twist to the proper socket to take it out of the tail light assembly and you can then replace the bulb.
It's behind the ashtray, it's a black relay and the easiest way to change it is to lift out the fuse box.
To remove the tail light assembly on a 1986 Celebrity: Inside the trunk next to the quarter panel there are studs with nuts on them that hold the rear header panel in place. Remove the center nut, which should be in the center of the taillight assembly. Then pull back on the lens so that the stud comes out of the body. Then pull sideways to pull the retainer tab out of the back up light assembly. Then you can twist out the socket that holds the bulb you need to replace. Replace the bulb and mount the tail light assembly back in place. Reverse these instructions to put the tail light assembly back in place.
the magneto