0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the fuse panel in 1989 Mercedes 560sl?
The fuse panel for a Mercedes 560 SL is on the side of the passenger footwell. You may need to move the carpet pad. It pops out.
How do you replace the ignition switch on a 1982 Mercedes 300SD?
To replace the ignition switch on a 1982 Mercedes 300SD, disconnect the battery and remove the horn pad. Locate the wire behind the horn and remove.
How do you replace hood pad 1997 600 Mercedes?
You'll have to go to your local MB dealer to get a replacement pad. Pop the hood and cover the engine compartment with a tarp of some sort, its could get messy, depending on the condition of your hood. Just grab hold of the old hood pad from the sides, where it's tucked in and start yanking it off the hood. You'll probably end up with a bunch of pad bumps that remained glued to the hood. Take a very light solvent to remove as much of the old pad as possible. You want the surface to be smooth and clean and free from any oils because you'll be using an adhesive to secure the new pad. There's some great spray on glue, normally used by upholsterers. You can get this stuff in most auto parts stores. Spray on a light, first coat on the pad and let it set for a little while. Then, when the car hood is dry and clean, carefully spray the center of the hood...stay away from the edges because you'll get glue all over the paint.. Respray the pad and start from the back of the hood and one side edge to line it up. BY THE WAY...YOU'LL NEED AT LEAST ONE OTHER PERSON TO HELP YOU WITH THIS PROJECT...TRUST ME. Quickly, begin to lay the pad onto the hood...smooth it out as you go. If you lined the pad up correctly, it will be fine. Keep patting the hood down, making sure the adhesive is sticking...keep doing this until there are no air pockets, and the hood stays put on its own. BAM!....you're done....its really not hard to do this, its just awkward at times because its a big pad, and you;re working upside down for the most part.
DYI 1996 Mercedes E 300 front disk pad replacement?
I need to replace the front disk pads on my 1996 MB E300
How do you reset the brake pad warning on a Mercedes C180?
remove the sensors and clean it. then put it back. if the warning light is still replace the sensors it is cheap
Which brake pad wear sensor goes on which wheel of 2003 Mercedes e500?
The E500 Brake Pad Wear Sensor goes on to the wheel of the 2003 Mercedes E500.
How do you replace front brake pads on a 1986 420sel Mercedes Benz?
Remove the tire and wheel from your 1986 Mercedes-Benz 420. Remove the brake pad spring and caliper. Reverse the process to install the new front brake pads.
Instructions on how to replace brake pad on ford F-100?
instructions on how to replace brake pad on 1980 Ford F-100
How do you replace a hood pad on a 1964 nova?
They sell repro hood insulation precut to size. the braces usually hold it pretty well by themselves but just to be on the safe side, buy some spray on upholstery adhesive in aerosol can, spray the backsides then press on.
Brake pad replacement for mercedes-benz c280?
Remove the Mercedes-Benz wheel and tire. Remove the brake pad and hardware. The brake pads will come off. Reverse the process to install the new brake pads.
How do you reset the brake pad warning light for a 01 c320?
How do you reset the brake pad warning light for a 2005 c320 mercedes benz?
How do you replace a horn on a '94 corolla?
To replace the horn on a 94 Toyota Corolla, you will need to remove the horn pad from the steering wheel. Once all screws have been loosened, you can lift the pad and replace the inner button, then just put the horn pad back on.
