stick your meat puppet in it,spray ether up your gaping hemmoroids, then light your farts
breather pipes.
The heater hoses connect the block, radiator, heater core, and waterpump. To replace, drain the radiator and catch the anti-freeze for recycling. Remove the hoses and put on new hoses. It is kind of nasty but not very difficult.
Check the air filter to see if it is stopped up. Check all the vacuum hoses for a leak. Replace the PCV valve.
Remove the sparkplug cables, breather hose, and remove the valve cover. The gasket is a permanent type and comes as a 5 piece kit that simply pushes into groves in the valve cover. Once installed, replace the valve cover and connect the breather hoses and sparkplug cables.
This is the escort forum not the ford taurus.
thats the heater control valve
Mark all hoses before disconnecting it after that disconnect them. Remove the valve. Install a new one, connect the hoses according the marking. PS: you might have to reset the computer, it's recommended every time you change one or more sensors, electric valves and so on.
it is located on the passenger side wheel well...it has 4 hoses attached 2 going into the heater core and 2 going into the engine...simply disconnect the hoses and replace with new heater valve
It connects to the crankcase vent, the air filter and the valve cover.
There are 2 hoses coming out of the PCV valve. One goes to the top of the engine and the other goes to the air intake at the air filter.
the ford escort zx2 2.0 dohc don't have one it's equipped with vct(variable valve timing) to replace it
how do i replace the pvc vacuum hoses?