Want this question answered?
If, after close inspection you do not see any damage to hub, you can use it. But ALWAYS install new bearing race with bearing.
A wheel bearing is pressed in to the hub so that it is able to safely operate. To replace a bearing on a Chevy Impala remove the hub from the car and take the unit to a machinist. Have the press out the old bearing and press in the new one.
It's a sealed unit with the hub. You have to replace the whole hub assembly.
103ftlbs
taking out rear hub asembly on a 2002 Chevy ventura
idk ask a freaken car person --HARRY POTHEAD
It has 1 big hub bearing per side and you can not service them. It has factory sealed bearings. If there bad then you must replace the bearing.
Hub/bearing assembly to steering knuckle bolts, 77 ft lbs.Axle nut, 103 ft lbs.
Could be the brakes are gone or it could be a hub and bearing assembly about to fall off the front of your car.
Yes it can be. I think you need to replace the whole hub assembly
You can replace both... Bearing or Hub... Bearings are cheaper, but harder to find and replace. Hub assemblies are easier to replace, but slightly more expensive.
36mm. You will also need an 18 mm box wrench to replace the bearing assembly.