0
You have to drop the trans pan to do it. Remove the cable from the carb and bracket. There is one bolt where the cable runs into the trans. Remove that bolt. After dropping the pan you'll see how the cable is mounted inside the trans. Remove the retaining clip and pull the cable out. Reverse for installation.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What causes the odometer and speedometer not to work on a 1987 Supra?
probably need to replace the speedometer cable. if turbo check the big one that goes along the firewall possibly got burnt up on the down pipe
Do you need the kickdown cable on a turbo 350?
No, but without it you'll need to manually shift it up and down for passing or other quick acceleration situations.
How do you replace shift cable for 01 cavalier?
The shift cable on an 01 Chevy Cavalier is replaced by removing the retaining screws, removing the cable from the shifter, and pulling it from the vehicle. A new cable can then be locked into place and bolted down.
Is there anyway you could fix your kick down cable in your Geo Tracker with the existing cable the tip snapped off but it is still intact just does not seem to have any tension?
you might be able to adjust it down at the trany, but it would be better to just replace the hole cable
Your 1999 mercury cougar is cutting out going down the road?
check the recalls there is something in there about the throttle positioning cable that was manufactured with a burr on the end of the cable... try that they will replace it for free.
How do you replace sunroof cable Mercedes 450sel?
Remove the Sunroof inner cover by prying down the front. This will expose the underside of the sunroof. Remove the keeper from the shaft in the center front. This is the end of the cable. Activate the sunroof motor and the cable will be forced out the front. There is about 12 inches of solid shaft then the cable begins. It is messy! ! ! . When the cable stops moving out, pull it out with your hands. To install a new cable, grease it, slide the end down the tube until it stops, then press the motor switch and draw the cable into the feeder tube to a length appropriate to match up with the position of the sunroof cable mounting bracket, insert the cable and replace the locking pin.
How to replace antenna mast for a Honda accord?
THE ANTENNA MAST OPERATES ON A PLASTIC CABLE WITH TEETH ON IT. WHAT HAPPENS IS THE TEETH WEAR OUT OR THE CABLE BREAKS. TO REMOVE THE OLD CABLE REMOVE THE NUT ON TOP AND TURN RADIO ON AND PULL OUT THE OLD CABLE. TO REPLACE THE NEW ONE STICK THE CABLE IN THE HOLE, TURN THE RADIO OFF AND THE MOTOR WILL PULL THE CABLE AND ANTENNA IN AND DOWN AND REPLACE THE NUT. MAKE SURE YOU HAVE ALL OF THE OLD CABLE OUT. IF NOT YOU CAN ACCESS ANY BROKEN OFF PIECES BY REMOVING THE COVER PLATE ON THE SIDE OF THE ANTENNA MOTOR. I HOPE THIS INFORMATION HELPS.
How do you replace a battery in a 1996 Buick regal?
Remove - battery cable Remove + battery cable Remove hold-down bolt on front bottom of battery tray Remove battery
Will a turbo 350 transmission from a 250 inline 6 bolt up to a gm 305 engine. tranny from a 73 and engine from an 88?
Yes. May have to improvise the kick-down cable.
Where is the starter in a 1972 Buick skylark?
It is located on the passenger side of the motor below the passenger side valve cover. You can follow the RED, positive, battery cable down to it as the cable should be connected to the stater motor.
My Cable modem periodically slows down a lot and almost stops.How do I fix that?
Call your cable modem service provider and have them run a series of tests on your line. If necessary, they will replace your modem, as well.
How can you open your hood on your 95 Pontiac transport if the cable is broken?
Reach under the front of your car between the radiator and the grill and pull the wire down. That will unhook your hood latch. Replace the cable.
