Want this question answered?
replace the high beam bulb
Unscrew the Bolts, however there may be from the inside. Turn left to loosen then twist off and replace bulb.
i had same problem,but i connect high beam of right hand side wire with left side high beam wire(by using extra wire between them) it is working like this__ i i ( left hand beam bulb)i i
You probably just have a burned out light bulb. Look at the back of the sealed headlights. You will see two connectors, one for the high beam and one for the low- beam. To remove the light bulb turn the bulb holder counter clockwise until it releases. Replace the bulb and holder. Make sure you don't get oil from you hands on the bulb or it may shorten the operating life.
Replace the left size high beam light.
If it is your low beam buy 9006 bulb. If it is your high beam buy 9005 bulb. Under the hood on left front side you will notice the back of the headlight assembly. In the center will be the bulb, turn it to the left or the right and take out...replacement is reverse from removal with a new bulb making sure you do not touch the new bulbs glass. The right side is the same accept for a plastic cover near air filter, use your discretion on taking off this cover it is not hard and the procedure is the same as the left side of the car.
expose back of bulb, turn to the left, replace bulb, return to socket, turn to the right
Have you checked the bulb , it has 2 filaments in it , see if one of the wires is broken
open the hood and there is a hook like lever close to where u see the headlight housing move it down and then remove the bulb lens and or as i call it the eye ball then un plug the wiring harness from the low beam by depressing on the tab and then take the grey schroud off the back of the light housing there are tabs along the sides of it then to get the actuall bulb out u have to push down a springy wire then move it to the left and the walla wiggle the bulb out by tugging on the wire a bit then reverse the process and then u have replace your lowbeam headlight bulb
gently insert a small flat head screwdriver on the left side of the bulb plate a push to the left.... the entire should bulb frame will shift to the left and then you can pull the frame out to replace the bulb....
Bulb is blown. Replace bulb.
You have to take the whole light out and replace the bulb. Then make sure the lights are realigned.Its not that hard to do.