answersLogoWhite

0

What else can I help you with?

Related Questions

Lug nut key for 1995 Isuzu Trooper?

What about it.


How do you remove the auto locking hub on a 1995 Isuzu trooper?

To remove the auto locking hub on a 1995 Isuzu Trooper, start by loosening the wheel lug nuts and then raising the vehicle to securely support it on jack stands. Remove the wheel and tire, then unbolt the hub assembly by taking out the retaining screws or bolts, depending on the design. Carefully pull the hub off the axle, ensuring you don’t damage the axle splines. Finally, inspect any seals or bearings before reinstalling or replacing the hub.


How do you Remove hub cap on Saturn l series?

The hub caps are held on with the lug nut covers, these are plastic, and screw on the lug bolts if you use the lug wrench you can loosen the plastic hub cap lug bolts and be able to remove the hub cap without loosening the lug bolts. 2001 L200's have lug bolts rather than lug nuts.


What size lug nuts on Isuzu NPR?

41mm


How do you replace a lug on the front rotor assembly of a 1995 Isuzu rodeo?

The old broken one must be driven out and the new one driven or pressed in.


How do you replace lug nuts on a 1999 Isuzu Rodeo?

Pretty simple really just use a lug wrench ( there is one supplied with the vehicle ) and the appropriate key if it a security nut and remove it, then screw the new one on and tighten.


How do you replace front wheel lug bolts on 2000 neon?

Beat the old ones out with a hammer, push the new ones in the same way as far as you can, then zip them in all the way with the lug and an impact.


How many bolts on a Saturn tire?

My 2001 L200 has 5 lug bolts


What is lug nut size on 1999 Isuzu NPR HD?

41 mm


How do you remove the front tires from Isuzu Rodeo?

remove the six lug nuts


1996 ISUZU NPR lug nut torque specs?

325 ft. lbs


How do you change the rear wheel bearing on a 99 ford contour?

The rear wheel bearing is an assembly and is very easy to replace, just 4 bolts attached to the spindle. And you have to line the hole on the lug bolts plate, one at a time.