replacing the rear main seal is not an easy task. you should have a good amount of auto mechanical knowledge to attempt this. basically you need to remove the transmission from the car. this gives you access to the flywheel. the flywheel has a few bolts on it remove the bolt and your rear main seal is there. note if your car is standard take a good look at the wear on your clutch and flywheel while youh ave the trans down.
You need to replace the oil seal.
Remove the tire and wheel from your 1989 Toyota Corolla. Remove the end of the axle. Remove the axle seal. Remove the wheel bearing. Reverse the process to install your new wheel bearing.
Bad seal around trunk
how do i replace a wheel seal
not really that expensive, all you have to remove is the main drive belt and the balancer.. i charge about 150.
you have to separate engine and transmission
How do you change rear main oil seal in a 2000 Toyota celica gt. thanks
There are some oil additives you can get, that might stop the leak. But if the leak has developed, the only way to fix it is to replace the seal.
How hard is it to change the rear main seal in my 1992 toyota pickup , with the 3.0 V6
how do I replace the seal on a 1990 Toyota 4x4 pick up, where the transfer case meets the exterior housing of the manual transmission?
remove transmission, remove rear main seal, install new rear main seal, install transmission.
You must remove the transmission are engine to replace the rear main seal.