Want this question answered?
wjjeeps.com . they show how to replace every light and with what bulb
Hard to see, but on my 96 Jeep Gr Cherokee there are two small screws next to each lamp on the outside.
replace rear tail light bulb
9004
To replace the brake light bulb you need to remove the whole light assembly. Once removed the change is simple.
take the screws out if the tail light and pull the old one out
1295
I had the same problem, all I did was replace the fitting that the bulb goes in with a new one ( $8.00 fix) and replaced the tail light and haven't had a problem since.
To replace the brake light bulb you need to remove the whole light assembly. Once removed the change is simple.Best Regards,Jon M. It is best to avoid touching the bulb directly because some bulbs will somehow burn out if touched. Cleaning it with rubbing alcohol after handling it should make sure it is going to last a long time.
How do it replace the stop light bulb
how do you replace a turn signal bulb on a 2004 jeep liberty. I can not find screws or a panel to go through
Unscrew the screw holding the lens on. Remove the lens and reflector assembly. Twist the rubber bulb holder to remove it from the lens/reflector. Pull the bulb straight out. Replace the bulb. Installation is opposite of above.