To replace the motor mounts on a Hyundai Santa Fe, first ensure the vehicle is securely lifted and supported on jack stands. Remove any necessary components, such as the air intake or battery, for access. Use a jack to support the engine, then unbolt the old motor mounts from the engine and the frame, and replace them with new mounts. Finally, reassemble any removed parts and ensure everything is securely fastened before lowering the vehicle.
The FE 352 cid ford motor has the same external dimension as all FE motors. Pre-1965 blocks (332, 361, 390, 427) have the same motor mounts. After 1965 engines have a different mounting holes, some machining/drilling would be needed, or custom motor mounts.
replace a starter in a 2001 hyundai santa fe
how do you replace rack and pinion seals on a 2003 hyundai santa fe
you need a new blower motor resistor with auto temp control
only possable if you have the same engine e.g 3s-fe to a 3s-fe but use the old manifolds and mounts for which the motor is going into ive done heaps of these but you cant change a 3s-fe in a 4s-fe then the mounts are slightly different but not hard to make new ones.
Onde está o numero do motor da santa fe 2010
Remove and replace it.
To replace the rear wiper motor on a 2006 Hyundai Santa Fe, start by removing the rear wiper blade and the plastic cover that conceals the motor. Next, disconnect the electrical connector and remove the mounting bolts securing the motor. After taking the old motor out, install the new one by reversing the process: secure it with bolts, reconnect the electrical connector, and reattach the plastic cover and wiper blade. Finally, test the new motor to ensure it operates correctly.
=
Check here for headers & motor mounts: http://www.critesrestoration.com/comet.htm You will also need to modify the front suspension to put an FE motor in a Falcon.
To replace the blower motor resistor on a 2003 Hyundai Santa Fe, first, disconnect the negative battery cable to ensure safety. Locate the resistor, typically found behind the glove compartment or under the dashboard, and remove any panels obstructing access. Disconnect the wiring harness from the resistor, unbolt it, and replace it with the new part. Reassemble everything and reconnect the battery to test the new resistor.
The answer is here, along with some discussion. http://www.hyundai-forums.com/t22513-santa-fe-speakers-what-size.htm