The FE 352 cid ford motor has the same external dimension as all FE motors. Pre-1965 blocks (332, 361, 390, 427) have the same motor mounts. After 1965 engines have a different mounting holes, some machining/drilling would be needed, or custom motor mounts.
replace a starter in a 2001 hyundai santa fe
how do you replace rack and pinion seals on a 2003 hyundai santa fe
you need a new blower motor resistor with auto temp control
only possable if you have the same engine e.g 3s-fe to a 3s-fe but use the old manifolds and mounts for which the motor is going into ive done heaps of these but you cant change a 3s-fe in a 4s-fe then the mounts are slightly different but not hard to make new ones.
Onde está o numero do motor da santa fe 2010
Remove and replace it.
=
Check here for headers & motor mounts: http://www.critesrestoration.com/comet.htm You will also need to modify the front suspension to put an FE motor in a Falcon.
To replace the blower motor resistor on a 2003 Hyundai Santa Fe, first, disconnect the negative battery cable to ensure safety. Locate the resistor, typically found behind the glove compartment or under the dashboard, and remove any panels obstructing access. Disconnect the wiring harness from the resistor, unbolt it, and replace it with the new part. Reassemble everything and reconnect the battery to test the new resistor.
The answer is here, along with some discussion. http://www.hyundai-forums.com/t22513-santa-fe-speakers-what-size.htm
looking for a diagram to remove and replace a crankshaft sensor for a 2004 Santa Fe 2.4 cyl.