0
How do you replace new side mirrors on a Chevy S10 1996 pick up?
Wiki User
∙ 16y ago
well first thing u do is remove the door panel. after that is done then there are 3 nuts that hold the mirror to the door, remove them and its off. (unless its power then u have to unplug the power wire then its off).
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you replace the front drivers seat on a 1996 Chevy S10 pick up truck?
How do you replace the front drivers seat on a 1996 Chevy S10 pick up truck
How do i replace therear wheel bearing on a Chevy pick-up?
how do you replace the rear wheel bearing on a Chevy pick up
How do you replace the door speakers on a 1996 Chevy s-10 pick up truck?
You need to remove the entire door pannel. There are manuals that show you how to do it.
What is needed to replace ball joints on 1996 Chevy Z-71 pick-up?
you will need a grinder, a crowsfoot, jack, jack stands. IF you are not experienced dont try it
Can you siphon gas from a 1996 Chevy S10 pick up?
YES.
How do you replace a water pump on a 97 Chevy pick 1500?
by a Honda
Can you replace a 1964 Chevy pick up standard bed with a 1964 Chevy short bed?
No, the frames are different lengths.
1991 Chevy S-10 rear seals?
how to replace the rear seals on a 1991 Chevy S-10 pick-up truck
What is the fuel pressure on a 1996 Chevy pick up?
minimum fuel pressure is 52 lbs to start
Where is the cam shaft position sensor on a 1996 Chevy s10 4.3L pick up?
That would be the distributor.
Do I have to replace just the fuel pump or the entire assembly on a 1996 Chevy K1500?
I have a 1996 K1500 and you do not need to replace the whole sending unit unless your fuel guage is not working properly. Just make sure that you replace the fuel pick up screen when you replace the pump, do not reuse the old screen as it may reduce your new pumps ability to pick up fuel resulting in low fuel pressures. I have a 1997 K1500 and have replaced only the pump a couple times. It is much less costly than replacing the entire tank level sensor etc..
How much does it cost to replace a clutch on a 1996 gmc sonoma pick-up?
I brought my Sonoma in for this this morning and my quote was $1900 for the whole deal. $1900 was my quote for my clutch, this is from a Chevy dealer service deaprtment. I have not seen the breakdown of parts and labor.
