One 10mm bolt holds the crank sensor to the top tranmission bell housing on the left side. From underneath bend the shield back that hides it and take the bolt out .. you can access the plug to disconnect the wiring easier.
it is inside the distributor.
Check
I would like to know where the cam sensor is on a 1999 pathfinder and is there one or they calling it a crank shaft sensor The cam shaft position sensor is located in the distributor.
in bthe sky
The crank sensor is on the left side top of the bell housing behind a shield. One bolt to remove but be careful as the wires are extremely thin.
if you have a code w/ cam to crank reference then yes. if only a crank sensor issue the no
How do you replace crank shaft sensor on 2005 Chrysler 2005 300c?
Usually pretty common to have the replace the crank sensor or crank angle sensor. Before you do replace the camshaft sensor check that your timing is right on because this is the issue with about 75% of vehicles.
How much will it cost to replace a cank sensor on a Mazada 626?
The crank position sensor (ckp) is located at the back of the motor,driver's side, mounted to the transaxle housing. It gets it's single from the flywheel teeth. First unplug it and then remove the retaining bolt and pull it up and out. Reverse precedure to install.
Where is the crank position sensor 0n a 2001 mitsubishi Galant
Bob