Want this question answered?
You need to get it up on ramps and remove the inner wing cover to access the bulb. Modern cars are great aren,t they?
To replace the dome light on a Grand Am, unscrew the light cover. Pull it down gently. Disconnect the light. Connect the new light, replace the light cover, and replace the screws.
easier to buy a complete new light mate
Take the oldest one out 1st
it depends on the age of the vehicle. Older ones have hydraulic PAS. The fault could be in the pump, the Rack, a leak, or as simple as a low fluid level. More recent Corsa's have an electric system (you will see a light on the dash "ESP" for Electric Power Steering when starting the engine.) If you see this light when starting or driving, the fault is in the steering column or control unit, and is not uncommon.
I don't think you can replace just cover. Usually you have to get a new tail light.
How do you replace a broken tail light cover for a 2005 Nissan Pathfinder ?
To replace the dome light in your 2005 Toyota, you will need a flat screwdriver to remove the screws and pry the dome light cover from the light. You can then access the light to change the bulb or replace the entire bulb and cover.
How do you remove cover to replace brake light on 57 kia Rio
IT is in the sun
It depends on which bulb you wish to replace. Headlamp, stop light, reverse light, heater control illumination? This question is "too general" to answer.
To replace your brake light, you need to unscrew the brake cover from the inside of the trunk. Then you will be able to pull the old bulb out and replace it.