Want this question answered?
jack up car, remove wheel, may need a pry bar, remove 2 bottom bolts at bottom of strut. go into trunk area & find top of strut mount and remove the 3 or 4 nuts securing the top. push down hub assembly & pry outward, pull strut down and out. installation is opposite of removal.
The bottom strut mount is connected to the frame by two retaining bolts. Remove the retaining bolts to remove the strut mount. Reverse the process to install the new strut mount.
E-Bay?Hemming's Motor?
the same as every strut mount. to hold the struts
It is as simple as removong 2 bolts and replacing the mount. Goodluck, JOe
remove the rear wheel, undo the bottom bolt of the strut. inside the car remove the plasic paneling in the back covering the strut mount. unscrew both nuts and pull the strut out.
Compress the shock spring with a spring compressor. Remove the top strut bolt. Remove the bottom strut bolt. Reverse the process to install the new struts.
You've got 4 mounts total. A transmission mount, then on the other side of the motor, you've got a mount that goes to the middle of the engine that is in the fender, and upper torque strut and a lower torque strut on that same side.
The same way you do any macpherson strut assembly...If you aren't familiar with the procedure, take it to a professional. Spring/strut assemblies can be dangerous if not serviced properly.
there are 4, each above the strut holding the spring on
Strut mount and suspension strut mount are very crucial parts of the vehicle. These are the aftermarket auto parts manufactured to replace the damaged original parts in any vehicle. Sujan Industries is the leading manufacturer and supplier of these two crucial aftermarket auto components in India and abroad. Here, all the products are long-lasting, help to extend the longevity of the auto car and also provide driver and passenger satisfaction. Strut mount is used to attach the suspension strut to the vehicle. It aids in minimizing vibration and tire noise. Its front part helps to link to the strut assembly to the car and the rear part is attached to the strut. In the middle, a rubber-like cushioning material is used. So when the car comes over any bumps during motion, the agitation pushes and pulls at the mount. The suspension strut mount absorbs the vibration and noise and the entire strut helps to minimize the noise and vibrations from spreading out. It is located at the top of the suspension strut assembly. Its main function is to mitigate vibrations and shocks. At Sujan Industries, all the auto parts are of premium quality, customized and affordable. So for any related requirements, get in touch.
Take the strut from the left and use this