0
The rear washer nozzle snaps onto the wiper arm.
While you have the wiper off, you may want to replace the trim ring that goes around the wiper shaft which the washer hose plugs into, as it becomes brittle with age and the nozzle on the trim ring breaks easily. It's held in by one large, narrow nut.
Many Jeep dealers still have that part, and it's under $10. Don't be surprised thinking that your trim ring is gray and you find that the new one is black!
What else can I help you with?
Where is the fuse for the brake lights on a 1993 jeep Cherokee?
Fuse panel. under the hood by washer reservoir
Where is the computer located on a 1993 Jeep Grand Cherokee?
It is on right side firewall under the hood behind the windshield washer bottle
How do you replace 1990 Jeep Grand Cherokee knock sensor 6 cylinder?
The Jeep Grand Cherokee didn't exist until 1993.
How do you replace the windshield washer motorpump on a 1993 mercury villager gs?
Remove the wiring harness from the back of your 1993 Mercury Villager windshield washer motor pump. Remove the windshield washer pump hoses. Remove the windshield washer pump retaining bolts. Reverse the process to install your new windshield washer motor pump.
Where is the ac orfice tube on a 1993 Jeep Grand Cherokee?
It is made into the liquid line, you have to replace the line to service.
How do you replace the speedometer cable in a 1993 Jeep Grand Cheroke?
A 1993 Jeep Grand Cherokee does not have a speedometer cable. The speedometer signal comes from a sensor on the transmission or transfer case.
Can I replace my 1993 Jeep Grand Cherokee PCM module Computer with one from the junk yard if the part numbers match?
yes
Will a 1993 Cherokee motor work in a 1991 Cherokee?
Yes
Can you replace the Dana 35 rear axle in your 1993 Grand Cherokee with a Chrysler 8.25?
Not without modificationsNot without modifications
How do you replace a windshield washer pump on a 1993 Mazda 626 DX?
To replace the windshield washer pump on a 1993 Mazda 626 DX, first, disconnect the negative battery terminal to ensure safety. Then, remove the washer reservoir by unscrewing any fasteners and disconnecting the hoses. Take out the old pump from the reservoir, install the new pump, and reconnect the hoses and electrical connector. Finally, reassemble the reservoir and test the pump to ensure it’s functioning properly.
Does the windshield for a 1994 grand Cherokee fit in a 1993 Cherokee?
Yes
How do you reset the computer on 1993 Jeep Grand Cherokee Laredo?
you usually reset the computer by removing the negative battery terminal for about 5 minutes, then replace it
