0
Can I replace my 1993 Jeep Grand Cherokee PCM module Computer with one from the junk yard if the part numbers match?
Wiki User
∙ 11y ago
yes
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Does the computer have to be reprogrammed if you replace the body control module?
yes
Does a 1991 Jeep Cherokee have a computer module to read codes and where is it?
http://www.jedi.com/obiwan/jeep/dtc.html
Does a 1993 jeep grand Cherokee Laredo with a 42RE transmission have a control module that has to be reprogrammed after replacement?
It does have a computer, no programming should be necessary.
How do you replace the ABS module on a '97 Jeep Grand Cherokee?
grand Cherokee abs module replacementit is located on the drivers side inner wheel well (under the hood) and mounted vertically. the black electrical connector has a silver clasp on it. lift the silver clasp and pull the connector off the module. there are 3 bolts that hold the module to rubber bushings on the bracket. relatively easy to do - about 20 minutes if you are not mechanically inclined.
Where is the ignition switch module located on the 1988 Cherokee limited?
module locatedwhere is the module on a 9 Chevy blazer
Can you just replace the transmission control module on a 1999 dodge ram?
The transmission is controlled by the engine computer. It can be replaced.
Where exactly is the transmission control module located on a 98 jeep grand Cherokee 4.0L?
Most likely it is in the power distribution box located on the passenger side of the engine compartment just aft of the battery. Open the cover, there is a diagram on the underside of the cover.
Where is the engine control module located on a 1993 Jeep Grand Cherokee?
The 1993 Jeep Grand Cherokee engine control module is located on the firewall in the engine compartment. The engine control module will be on the passenger side of the firewall.
Where is the ecm relay for a 1989 mustang?
it should be on the passenger side kicker panel right above the computer. I just pulled my relay out to replace and everyone says that is for the ecm. electronic control module aka computer, or powertrain control module.
What does code p0513 means for jeep Cherokee Laredo 2005?
Basically it means it means you have a invalid skim key and you are going to have to replace the i mobilizer module with new keys and reprogram.
Where is the fuel regulator on a 2004 jeep Cherokee with a 4.0 engine?
On the pump module in the tank.On the pump module in the tank.
Does a 94 jeep grand Cherokee have a vacuum module on trans?
No.
