trouble putting right front signal bulb in.
Check the fuse for the wipers and replace the turn signal bulb.
Get a creeper and go at it from the bottom, all of what you need is right there.
To replace the front right turn signal light, you would typically need to access it from inside the hood near the headlight assembly. Depending on the make and model of the vehicle, you may need to remove the headlight assembly or a cover to reach the turn signal bulb for replacement. It is recommended to consult the vehicle's manual for specific instructions.
i need to replace a throttle sensor and put a throttle body rebuild kit in
One of the front blinker bulbs is burnt out. Replace the bad bulb and the blink should function normaly. you have a front right turn signal bulb that is burned out. the resone it blinks fast is there is less load on the flasher .
First pop your hood. After you raise the hood, and your looking at the front headlights. Directly above the headlights. In each corner of the headlight is a screw. remove that screw and pull the signal light right out. turn it over to replace old bulb. Once your done reinstall turn signal. Then tighten screw back!
Reach behind the bumper of the 99 Cavalier. There are two nuts that hold the turn signal assembly in. Remove the nuts to take the assembly off and replace it.
I would replace the turn signal switch.
Replace the signal flasher relay assuming you have physically seen front and rear, left and right signal bulbs flash.
says how to do it clearly in the owners Manuel but all u have to do is open the hood clip it off
pivture to change right turn signal