0
The ring and pinion gears in the drive axle gear box is a very precise installation. Special measuring devices are needed because clearances and torque settings must be closely adhered to. Not a backyard mechanic job.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you replace front ring and pinion on a 89 Toyota pickup 4x4?
how do you change front ring and pinion on 89 Toyota pickup
Can you replace the differential ring gear without replacing the pinion gear?
No, they are a matched machined set.
What is the stock gear ratio in a 1990 Chevy truck?
More then likey it has a 3:42 gears. But the way to know for sure is to COUNT the teeth on the ring gear and the pinion gear and then divide the pinion into the ring gear and that will tell you for sure.
2001 Chevy blazer pinion seal replaced and noise heard now?
It sounds like the pinion nut is not tight enough and the pinion is now moving in and out. This will do bad damage to ring and pinion. You will need to replace crush sleeve in rear end now.
How many teeth are on a ring gear and pinion for a 3.07 gear ratio?
43 ring gear 14 pinion
How do you figure out the ring size on a 1990 Chevy pickup?
Count the # of teeth on the ring gear. Now count the # of teeth on the pinion gear. Now divide the small # into the big # and that will be your gear ratio.
How do you get a gear ratio?
count your teeth on your ring gear <big gear> and on you pinion <little gear> and the divide the ring gear teeth by the pinion
How many teeth on a ring gear and pinion gear for 4.10 gear ratio?
41 teeth on the ring gear, 10 on the pinion gear.
Why cant i get front axle to engage on 1990 Chevy 1500 4x4 replaced actuator and switch on houseing and switch on tcase tcase is spinning front drive shaft but axles are not locking in?
There is either a problem with the actuator in the front differential--BAD ACTUATOR. Are there is a problem with the differential ---RING and PINION asembley.
How do you change 1990 Chevy 1500 305 fuel pump?
you need to drop the fuel tank,since this is where the pump is. once the tank is down you can see the lock ring. remove and remove pump. be sure to replace strainer too.
What is the funcion of a ring gear?
It is to transfer the power between the driveshaft and the wheels. The drive shaft drives the pinion, the pinion drives the ring gear, the ring gear drives the axle(s) and the axle(s) drives the wheels.
What is used to connect the pinion gear to the wheels?
ring gear
