Use a breaker bar to loosen the tensor wich is directly below the Alternator on the 3.0 V6. While the breaker bar holds the tensor down (loose) slide on the new belt via the diagram in the compartment.
belt assembly for a 95 Plymouth voyager
It can cost between $14 and $30 to replace a serpentine belt on a car. The price can raise to $40 or $60 if a person has it done at a car shop.
Chilten's repair book or Haynes' repair book for Chrysler 95 lebaron Usuallya 95 Chrysler lebaron is 3.0L Look in the book for diagrams for 3.0L or the engine you have To find your engine Look under hood Your engine should be on top engine cover My guess is it is a3.0L
i'am replacing a serpentine belt on a air condition compressor. i would like some diapham or step instructions would work the best thank you roger
serpentine belt.
serpentine belt rought 2001 Saab 9.5
If it
Use a socket and ratchet and place on the 95 Deville's belt tensioner pulley. Pull to the side to release tension on the belt. Remove the belt and replace it, then lower the pulley back into place.
Use a socket and ratchet on the bolt that holds the 95 Park Ave serpentine pulley. Pull the ratchet to the side and the pulley will swivel, loosening tension on the belt. Remove the belt, install the new belt in the same manner.
Take a 14 mm wrench and put on the center bold of the tensioner. Then pull back releasing pressure on the belt. Remove and replace. Take a 14 mm wrench and put on the center bold of the tensioner. Then pull back releasing pressure on the belt. Remove and replace.
On vehicles with a single serpentine belt, tension is usually self-adjusted automatically via a spring loaded tensioner. No additional adjustment is necessary. If the belt is slipping or loose, then it needs replacing. Also check the tensioner bearings and replace the tensioner if necessary.
I have a 95 GC Laredo and the routing diagram for the serpentine belt is on the fan shroud. Perhaps yours is there as well?