open trunk the tail lamp assemblys have to come out you should see 2 bolts around tail frame remove w/ 10 mm socket now go inside trunk pull carpet away from tailamp locatioe ther is a 10 mm nut remove this nut now pull light housing away from car you will see bulb acess sockets they are twist counter clockwise and pull make sur youput correct bulbs in some bulbs are2 fiament you can tell by counting the contacts on bottom of bulb some are one dont mix them up chang one at a time bulb is also a push and left tist to remove good luck.
See sources and related links below for bulb information.
This is for the Heater/Fan/Cooler lights. To replace the bulbs remove the control knobs by pulling them off, the front panel can be pulled off using a small screwdriver, pry it off on the right side then remove the clear diffuser panel and twist and pull the small bulbs out. There are 2 bulbs for that heater knob control. (bulb # 90069-98004)
It means that one of the bulbs is out on one of your brake lights, whether it is the back window, right or left side, or in the spoiler.
To fix faulty daytime running lights on a 1996 Chev Suburban, check if the bulbs are blown. If so, replace it. If the new bulbs are blown immediately upon replacement, check the wiring running to the headlights.
GO AND BUY I NEW light bulb !
You have to replace the entire light unit. The bulbs are not replaceable. Try a junkyard or Ebay for used units.
It means that one or more rear bulbs on your vehicle does not work or have a bad electrical contact.
Check the bulbs Check the flasher
the whole light or just he bulbs?? just the bulbs
replace it.
Simple your tail light bulbs have fused and needs replacing
See *Rear Combination Lights* on page 10-53 of your "Owner's Manual", under Section 10: Maintenance and Service - Replacing Bulbs.....
The headlamp bulbs on a 1996 Acura TL are installed from the engine bay. Find the housing located in the front of the vehicle. Disconnect the bulbs and replace them with new units.