0
How do you replace the 6''x 9'' in the back of your 2001 Dodge Intrepid?
Wiki User
∙ 18y ago
You need to remove the rear seat cushion and seat back, then remove the two side panels on either side of the rear deck, then lift up the rear deck to gain access to the two 6x9's.
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
Where is the bank 02 sensor located po160 on 2001 dodge intrepid?
back 2
How do you fix a seat belt in a 1984 Dodge Intrepid that will not roll back up?
replace the seat belt
How do you replace the PCV valve on a 2000 Dodge Intrepid?
On the 2.8 it's on top of the plenum at the back. disconnect the hose & unscrew the pcv valve & replace.
What is the problem when you have to turn ignition key back to get power windows to work on 99 dodge intrepid?
your switch is going out....you may need to replace it
Can a Dodge Stratus motor and transmission fit in a Dodge Intrepid?
No, a Stratus engine sits transverse, while the Intrepid sits front to back.
How do replace a temperature sensor on a Dodge Intrepid?
just unplug the wires going to it unscrew it. then insert new one then hook wires back up.
How do you change the fuel filter on a 1995 dodge intrepid?
The fuel filter 1995 dodge Intrepid is on the passenger side. The filter is towards the back of the car.
Where is the O2 sensor on a 1994 Dodge Intrepid?
The 1994 Dodge Intrepid O2 sensor is located on the outside of the air cleaner housing. The sensor is on the back side of the housing.
Is there a reset button in 98 Dodge Intrepid to get the computer system back on after a rear end collision?
A Dodge Intrepid does not have a reset switch. The fuel system is computer controlled.
Where is the exhaust gas regulation sensor located on a 2001 Dodge Intrepid with a 2.7L?
It is part of the EGR valve on the back of the engine.It is part of the EGR valve on the back of the engine.
How do you replace the thermostat on a 2000 Dodge Intrepid with a 2.7 Liter V8 engine?
First thing I would do is go back to the factory and ask to have your other 3.0 litres to make it a v8
How do you remove the light fixtures in order to replace the brake lights on a 2001 Dodge Intrepid?
There are thumb screws in the trunk some are exposed and some you will have to pull back the carpet to acces when you remove these (4 per light I think) you can pop the whole light assembly off the car and work on it.
