If the blower doesn't work on certain speeds, replace the resister pack, located just behind the blower, against the firewall. If the A/C light is flickering on and off, replace the AC head unit. If it's just the blower that's causing the trouble, passenger side. There are two pieces to remove to get to the blower. Then you just unplug the motor, remove the screws holding it and slide it out.
if it is the same number on it!!
How to replace a window and regulator on a 1998 checy malibu?
Under the passenger side dash. It's awkward to get to, but it's there.
Chevy did not build a Malibu in 1995.
How do you replace a cigarette lighter in a 1999 Malibu
What is the best motor oil to use on a 1999 Chevy Malibu?
Preferably w/o a cig in your mouth!!
The head gasket on a 1999 Chevy Malibu is replaced by removing the coolant, intake manifold, and retaining bolts. The cylinder head can then be removed, the gasket replaced, and everything reassembled.
My 1999 Chevy Malibu has a fuse box under the front hood,
You cant, go to the junk yard or eBay
I purchased a used 1999 Chevy Malibu and had to replace the glove box because the latch was broken. I purchased another a the local salvage yard and I want to know how to take the lock out of the old door and install it in the new one.
how to replace water pump on a 1999 chevy malibu 2.4
YES. Alot of parts will interchange.
Where is located pressure sensor on Chevy Malibu 1999
Drain the oil from your 1999 Chevy Malibu oil pan. Remove the oil pan retaining bolts. Remove the oil pump retaining bolts. Reverse the process to install your new oil pump.
They only Head Gasket I had to replace was on a Chevy Malibu 1999. Cost me about $1400
Give me a diagram of the location of the thermostat on a 2001 Chevy Malibu
Yes. '99-'01 same
The 1999 Chevrolet Malibu brake light switch can be found beneath the dashboard, next to the brake pedal. The brake light switch simply plugs in and out.
Remove the wiring harness from the back of your 1999 Chevy Monte Carlo blower motor. Remove the blower motor retaining bolts. Remove the fan on the front of the blower motor. Reverse the process to install the new blower motor.
Remove surpentine belt,then take out bolt that goes through tensioner to engine.