CV Joints

How do you replace the CV Joints on a 1990 Honda Accord?

787980

Top Answer
User Avatar
Wiki User
2015-07-15 19:51:57
2015-07-15 19:51:57

You may want to go to a car parts store, or book store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.

If the CV boot is torn open forget about re-booting the joint, buy a remanufactured axle and replace it. If the boot is starting to crack or separate but has not torn open to the point you can see the cv joint itself you can re-boot it.

To replace the boot and/or halfshaft axle: First, remove the wheel cover and loosen the 36mm nut holding the joint to the bearing. Then raise the vehicle and remove the lower ball joint from the lower control arm and the knuckle. If your working on the passenger side, drain the transmission. Slide the half shaft out of the knuckle then use a prybar and pry the inboard end of the shaft out of the transmission or intermediate shaft, which ever should apply. Be careful not to damage the seal in the transmission. Installing the shaft is the reverse of removal. The inboard side of the shaft should snap right back into the intermediate shaft and transmission by means of a snap ring on the end of the shaft.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

How much does it cost parts and labor to replace a valve cover gasket on a 1990 Honda Accord 4door.

User Avatar

how to replace the water pump on a 1998 Honda Accord

User Avatar

The 1990 Honda Accord does not have a cabin filter.

User Avatar

It is located in the fuel tank. The tank must be removed to replace it.

User Avatar

how do you take out a transmission on a 1990 Honda accord

User Avatar

EM 6279 and EM316. Which of these works for my HOnda accord 1990 EX 5-speed?

User Avatar

You can use the 1990 stereo in your 1992 Accord, but the 1998 will not bolt in the correct way.

User Avatar

For more complete instructions, see: http://www.faqfarm.com/Q/How do you change a front corner lamp on a 1990 Honda Accord LX

User Avatar

If you haven't replaced the relay, check this website. It will show where it is located and how to replace. autorepair.about.com

User Avatar

The fuel pump of a 1990 Honda Accord is located underneath the rear seats. There is a circular service panel that allows a user to easily replace and maintain the fuel pump without dropping the gas tank.

User Avatar

Yes it does interchange. 1990-1993 Accords have the same camshaft pulley (or cog).

User Avatar

1990-1997 Honda Accord ALL - 4 x 114.3 1998-2002 Honda Accord 4Cyl - 4x114.3 1998-2002 Honda Accord 6Cyl - 5x114.3 2003-2010 Honda Accord ALL - 5x114.3

User Avatar

Get a 1990 Honda factory manual - it wil;l show you how. Get a 1990 Honda factory manual - it wil;l show you how.

User Avatar

I just had my alternator replaced on my 1990 Honda Accord and the final bill was $315.

User Avatar

cb7 = chassis code for the fourth generation(1990-1993) honda accord

User Avatar

Fires from right to left 1,3,4,2 1990 Honda Accord 2.2 liter SOHC L4 1-3-4-2

User Avatar

1. 1989 Toyota Camry2. 1990 Toyota Camry3. 1991 Toyota Camry4. 1988 Toyota Camry5. 1997 Ford F-150 4X2 Pick Up6. 1994 Honda Accord EX7. 1995 Honda Accord EX8. 1996 Honda Accord LX9. 1990 Honda Accord EX10. 1994 Honda Accord LX11. 1994 Chevrolet C1500 Pick Up12. 1992 Honda Accord LX13. 1991 Acura Legend14. 1995 Ford Mustang15. 1987 Toyota Camry16. 1990 Honda Accord LX17. 1995 Honda Accord LX18. 1989 Chevrolet Caprice19. 1988 Honda Accord LX20. 1991 Honda Accord EX

User Avatar

The correct tightening torque for a 1990 Honda Accord oil drain plug is 29 foot pounds. This same torque applies to all Honda oil drain plugs.

User Avatar

Check out this site for info on a 1990 accord VSS: http://www.cybertrails.com/~bestinthewest/autotips/999VSSTestLocation.html


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.