Alternators
Nissan Frontier
Toyota Previa

How do you replace the alternator on a 1991 Toyota Previa?

979899

Top Answer
User Avatar
Wiki User
Answered
2011-09-12 20:53:19
2011-09-12 20:53:19

The Alternator is held by "two bolts" located at the top(12mm) and bottom (14mm). Remember to disconnect positive side of battery. First loosen 10mm nut that holds positive cable at back top of the alternator, then unplug wire harness on back. Second remove the 12mm bolt at top form the back. Third remove 14mm bolt at bottom form front. When you remove these bolts you should be able to loosen and pry out with a flat screw drive.

012
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


There is no cabin ari filter on a 1991 Totyota Previa

It means you are having a problem with the charging system. Have the alternator and battery checked. Good Luck!!!

The location for the idle switch of a 1992 Toyota Previa mini van can be found in the Toyota Previa Auto Repair Manual 1991 thru 1995. This can be purchased from the Toyota dealership.

it has a 2.4li engine size for gasoline

I CHANGE MY OWN OIL IN MY 1991 PREVIA. 5W30 IS WHAT I HAVE USED FOR YEARS. PREVIA JUST PASSED THE 334,000 KM MARK

unbolt the negative power wire unplug the positive power wore remove the tension bolt on the top of the alternator remove the lower bolt and pull out the alternator

Not sure if 1991 and 1989 is sameNot sure if the alternator is under your right front seat on a 1989 model, but it is on 1991. You need to remove the seat and the top under the seat to get proper access. When that is done, it is easy removal of the alternator. You will see that the alternator is self explainable.

Jack location for Toyota PreviaToyota Previa jack and tire iron are located under front passenger seat. Access from front on door side. It is held down with a butterfly screw and/or rubber retaining band. Easy to get out.this is on most united state previa,most European made previa the jack are locate under the driver seat.

A diagram of a 1991 Toyota starter relay switch can be obtained from most Toyota dealerships. The starter relay diagram can also be found at most auto-parts stores.

Look underneth right beside the shaft going to the front

Under the dash behind the cruise control actuator, or so I have read.

you will need a new thermostat to cure this problem. ian

If you have 15" inch rims, the default factory tire size is p215/70.

Try and get someone to read the ECU codes, that will tell you if the problem is from the "Knock Sensor". If it is you will need to buy a new one and replace it. They are very expensive and can only be got from a Toyota Dealer. To fit your self Drill a hole under the front seat(Directly above the sensor) and replace from there. If you dont want to drill a hole you will have to drop the engine and that is not a cheap option on a previa.

Sensa trac sells for 65 a piece with lifetime warranty

Turn the key to acc. and push the plunger in located on the Ignition lock housing

Disconnect the 1991 Regal battery. Remove the alternator belt and wiring. Unbolt the alternator and install the new one. Reconnect the wires, install the belt, then reconnect the battery.

I am looking for the bulb number to replace a burnt out bulb on a 1991 Toyota pickup

Depends who does it. It could take upto 3 hours of labour and struts start around £65 for gas replacements. Oil filled struts are better but dearer.

About 200 bucks. Its about 80 to 130 bucks for the alternator, and its really easy to replace. Sits on top of the motor.

It's gotta come out from underneath the car.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.