Want this question answered?
To replace the brake light bulbs on a VW Polo, pull away the carpeting in the trunk, unscrew the bolt holding the lights on, and disconnect the wiring. Replace the bulbs, put the wiring and bolts back, then replace the carpeting.
you access the light cluster by getting through the boot and pulling back the carpet near the cluster. The whole thing comes out in one fiddly piece. replace the bulb and the whole thing clips back into place. I'm assuming by light you mean bulb.
To replace the back speakers in a 2006 Acura TL, remove the SRS housing on both sides and the back panel of the speakers. Remove all wiring attached to the speakers and replace.
Open back hatch and near the tail light inside the frame by rubber gasket you will see 2 screws. remove screws and the light fixture will come out. Just twist the bulb socket and replace bulb
How to replace a brake light on a nissan Tiida hatch back.
remove tail light, remove burnt bulb, replace burnt bulb, test if it works, then put tail light back on....
Take 2 screws out and pull light straight back, it will come over, replace bulbs and put back on and replace screws
lift the boot, and grab a screw driver and unscrew the light and then at the back of the light twist the bulb out and replace and twist it back in afterwards.
how to remove the alternator on 2006 dodge caravan 3.3 lite and also replace the new alternator back on 2006 dodge caravan
For a year 2000 UK Polo: You don't need to unscrew anything. If you look in the boot at the back of the rear light cluster (you may need to pull back a bit of the carpet that covers the back of the light cluster) you will see there there is a grey/black bulb holder. This holds all the bulbs for the real light cluster. It has has one or two clips with wires (depending on which side of the car you are looking at) connected to it. Unclip these. There are also two clips on the left and right hand side of the bulb holder (which hold it in place to the back of the light cluster) Unclip these, you should now be able to remove the bulb holder and replace the bulbs. For an 52-reg Polo: I just did it on my car. It sounds like you have a similar housing to mine - unscrew the plastic-covered screw top from inside the carboot. Then pull out the whole light housing -its held on by two snap-fits on the outer edge. Remove inner housing to reveal bulbs. Replace bulbs. Good luck. HW
Remove the connector from the back of your marker light assembly. The lightbulb can be removed by pushing it in and turning at the same time. Reverse the process to install your new side marker lightbulb.
Front or back?