Its located on the brake pedal. Unplug the wiring harness and unbolt it and replace it.
you need to replace the brake light switch that is located above the brake pedal underneath the dasboard Here's a link to a video that 1aauto.com has that shows you how to replace the brake light switch.
try finding the fuse box and look for the brake light fuse on see if it is broken
You have to go inside the trunk and remove the circular plastic covers from behind the lights. Then you have to unscrew the entire light and you can access the bulbs to replace them.
replace brake light switch located on brake pedal under dash
brake lights dont work
Located at the upper end of the brake pedal under dash area
If I understand your post: The brake light is on constantly? If so, you may want to adjust or replace the brake light switch located at the top of the brake pedal.
A diagram to replace the brake light on a 1999 Tahoe can be purchased from your local auto parts store. It is located in the Haynes 1999 Tahoe Repair Manual.
To replace the brake light on a 2000 Ford Explorer, remove the screws holding the brake light in place. Gently, but firmly, pull the brake light out of the vehicle and replace with a new one.
How to replace a brake light on a nissan Tiida hatch back.
w to replace center brake light in 2004 jeep liberty
In the top of the trunk near where the brake light is located, there is a small plastic window, remove it and you access the light bulb.
Remove the high mount brake light retaining screws from your Mazda Protg. Remove the high mount brake light wiring harness. Reverse the process to install your new high-mount brake light.
How can one replace a cornering light on 1990 Mazda dx
You might need to replace the back-up light sensor, located under the dash, by the brake pedal. The correct term is "brake light switch" instead of "back up light sensor." And yes, it is located above the brake pedal.
push it forward the it should come off
Brake light switch is located on the brake pedal arm. Unbolt & bolt in new one. Wiring will unplug & plug back in to new switch.
To replace your brake light, you need to unscrew the brake cover from the inside of the trunk. Then you will be able to pull the old bulb out and replace it.
Should be located at the upper end of brake pedal under dash area
Located at the upper end of the brake pedal almost under the dash
how to replace the brake light switch at the pedal of a 2001 ford zx2
how to replace brake light bulb fiat doblo van
If there is no brake lights on a 1998 Mazda pickup, check the fuse. If the fuse has blown, the lights will not work.
Most likely your brake light switch is either not adjusted properly or malfunctioning. It is located under the dash and the brake pedal will press it when it is applied. They are not hard to adjust or replace.