Measure each brake line and go to the parts house and get the necessary lines. You will need a tubing bender. Remove the old lines one at a time and bend as needed. install the lines and then fill the master cylinder and bleed each wheel.
i just had bought a 95 beretta n it needs new break lines is it best to just repair them or can i just replace the pice that needs 2 be fixed
You remove the wheels to replace brake lines.
You can not use rubber fuel lines to replace the current brake lines due to the high operating pressure. You will need to replace them with brake lines, the rubber brake lines has a different construction to hold the pressure and not getting eaten away by the brake fluid, brake lines can hold over 2000psi when the pedal is heavily applied
How do i replace brake lines on a 2000 grand am
Why would you want to replace all the brake lines? You can flush the entire system and install fresh DOT3 brake fluid. I can see no reason to replace all the brake lines. Why are you doing this? Unless your brake lines are rotted out or someone has cut them... there is no reason to replace all four lines.
It should only take about an hour to replace the brake lines on a 1995 Toyota Corolla. The exact time will depend on your experience with replacing brake lines.
3/16" and 1/4".
take it to the shop
Check
replace the line and fill and bleed breaks.
how to change brake lines on a 1996 ford econoline e-150
The 92-96 Beretta/Corsica brake master cylinder is best removed with the ABS pumps and reservoir still attached. First, disconnect the 4 brake lines going to the top of the unit using a flare wrench. Now remove the 2 bolts securing the brake master cylinder to the brake booster. The whole assembly will come right out. Easy!