Want this question answered?
Mounted somewhere on the brake pedal lever, or possibly a pressure switch on the master cylinder, depending on the vehicle.
on side of master cylinder.
To replace the pressure switch on a Jacuzzi spa you need to disconnect the wires from the thermostat to the pressure switch. Remove the pressure switch, replace with new one, and reattach the thermostat wires.
This device is the focus of a few different questions - from the symptoms caused by a leaking switch, to the TSB (Technical Service Bulletin) detailing the problem with the leaking switch.See "Related Questions" and "Related Links" below for detailed / photo how-to guides to replace the switch, and a website dedicated to the problems caused by, and how to make repairs.
The brake switch is located on the brake master cylinder!
It will either be a mechanical switch located on the brake pedal lever under the dash, or a pressure switch located on or near the master cylinder.
How I can replace ignition switch cylinder from Isuzu Rodeo?.
It is threaded into the master cylinder. If you can't reach from under, remove the fuel tank to expose the master cylinder and brake light switch.
Should be located on the brake pedal arm near the point at which the arm connects to the dash. If it has a pressure switch, it will be located near the Master Cylinder.
The switch is located down by the foot petal, near the brake booster shaft that pushes the master cylinder. Its not fixable, if it is inoperable, you replace it.
if your pressure switch acts up at all, replace it.
That is a low fluid level switch.