0
Once the wheel is off you have access to the brake assy. Look at the assy where the rotor goes through the pads. There will be two long pins running through the assy and through the pads. These hold the pads in place. On the back top side there is a stiff wire that runs from pin to pin and fits into a hole in the middle. Pull it out of the hole and then from the pins.
Note the position of the inner spring and then remove the pins and inner spring. Now with a large pry bar you can push the pads away from the rotor. This is necessary to allow the new pads to fit.
Now remove the old pads by lifting them straight out. Put disk quiet on the new pads and insert them into the assy. Reinstall all the parts in reverse order and bleed the brake assy with new fluid.
Your done.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you fix a 1992 Toyota 4runner heater core?
How do you bleed the heater after changing coolant in a 1992 4runner
What is the towing capacity of a 1992 Toyota 4Runner?
5,000 lbs. is what I saw
Where is the intake air temperature sensor on a 1992 Toyota 4runner 3.0ltr?
The intake air temperature sensor on a 1992 Toyota 4Runner will be found on the intake system. The unit is clipped into the plastic piping of the intake.
What type of oil does a 1992 Toyota 4runner sr5 use?
10w 30
Where is the thermostat located and how do you replace it 1992 Toyota Camry?
Where is the thermostat located and how do you replace it on 1992 toyota camry 4 cylinder ingine
How do you replace speed sensor on 1992 Toyota Previa and where is the sensor located?
How do i replace speed sensor on 1992 toyota previa and where is the sensor located
Where is the fuel filter located on a 1992 Toyota 4Runner?
The fuel filter 4runner v6 sr5 is located under the car, underneath the the front passenger seat behind the chassis..
How many quarts of transmission fluid should you put in a 1992 Toyota 4Runner?
Your 1992 Toyota transmission will hold 12 quarts of transmission fluid, when it is empty. You can check the transmission fluid level with the dipstick.
Where is the speed sensor located on a 92 Toyota 4runner?
If it's a 1992 V6 4Runner with an automatic transmission, the three wire speed sensor for the speedometer is located on the extension housing of the transmission.
How much to replace a clutch in a 1992 Toyota 4wd 4runner?
The most expensive part of a clutch job in your Toyota will be (as it always is) the labor; 5 to 6 hundred dollars. The clutch assembly is about 450.00$. There may be incidentals added to this, so bank on about 1,000.00$. I have a 1991 4runner with 312 thousand kiometres on the original clutch. Try to find that on any other model, North American or other.
What kind of brakes are on the back drums or discsi have a 1992 Toyota Previa le?
my 92 is dics
How do you replace a water pump in 1992?
how do you install a water pump on a 1992 toyota camry
