Want this question answered?
The way to replace a door handle on a Nissan pickup truck can vary depending on the year of the truck. There are several tutorials available online.
Underneath, just next to the rear righ door (if it's a double cab) beside the gas tank
Have to remove the door, then remove pins and bushings
by using only the information given, your answer is to replace the lower door hinge pin and bushing.
You should be able to get at the mounts from the inside of the rear fender
Getting the alignment(gap) right is the hardest. Just need to remove the headlight, raise the hood unbolt the fender bolts. The fender bolts near the door jam, You get access with the door open. You might need to remove the bumper to remove.
remove headlight there is 2 bolts there ,remove enter fender there is one nut that bolts the bumper to the fender,there is two bolts at the bottom of the fender next to the door.then one bolt in the middle of fender next to the door. then you got the bolts on top of fender under hood
first would be to remove the headlight and turn signal. remove any bolts behind there holding the fender. remove the screws holding the inner fender to the fender. at the bottom of the fender behind the tire there are 1-2 bolts that need to be removed. now open the door and remove the fender bolt/s in the door jamb. last is to remove the 4-5 bolts along the top of the fender under the hood holding the fender to the appron.
W/ a new one
the vin number is usually stamped in 3 places, the driver's side bottom corner of the windshield, inside the driver side door frame (there's a sticker) and on the frame thats a general answer for all vehicles, not just the Nissan
how to replace a blown bulb behine my 99 quest speedometer
open the hood. on the side of the fender that you want to replace will be a few screws. take them off with a 10mm wrench, then there should be two more bolts on the side of the car by the door.