this is a tricky one ... u need tools ex: slide hammer, 25 ton shop press 35mm socket for axle nut ,pickle fork ,15mm wrench
unload the spring: jack the car and place a jack stand under the subframe- this should unload the spring. undo the lower ball joint using the pickle fork. next undo the axle & nut pull the axle out of the bearing. next undo the brakes... using the slide hammer pull rotor off the car. now use a shop press to press the bearing out .. if you have no shop press u will not be able to do this. sometimes u will find a shop to do this for you for a few bucks or a 12 pack of beer.. it's going to take a few hours to do this job take your time .. good luck
If you need to ask on here, then you shouldn't be doing it yourself. Take your car to a garage.
what is the torque on front wheel bearings for 1998 honda accord
yes they do. I have a 1991 Honda civic and I needed to press them in and I believe they have the same front end.
How to replace left front door actuator on a 2005 honda accord hybrid
Is it the back one or is it the front one...?
It is about $300 to $350 in Flushing NY
too much
Front studs on a 1999 Honda Accord are pressed in. First the studs must be removed using a hammer or press. Once remove each stud can be pressed in.
The 2004 Honda Accord has 40.4 in. of front head room.
The 2008 Honda Accord has 42.5 in. of front leg room.
The 2014 Honda Accord has 39.1 in. of front head room.
The 2001 Honda Accord has 42.1 in. of front leg room.