After car has set over night.
Make sure your new filter has 2 new clips. 99.99% of the time the old ones break.
Use a screwdriver on the filter housing. Its on the passenger side under the rear door. You will be able to pry off two clips and remove the lines. Get ready for a small amount of fuel to come out of the filter.
Remove old clips and lines. And install clips and lines in reverse.
Then after you have it all together, Turn key to RUN not START..Listen for fuel pump sound. Leave key on run and check for leaks. Cycle off and Cycle key back to RUN..Check again if no leaks...Start car.
Now go wash your hands you dirty monkey.
where is the DPFE sensor located on a 2002 ford crown victoria?
According to the 2002 Ford Crown Victoria Owner Guide : With engine oil filter change : ( 5 quarts / 4.7 liters of engine oil )
5 quarts WITH ENGINE OIL FILTER CHANGE , according to the owners manual
2002 ford crown Victoria how to repair crank sensor?
a 2002 p71 crown Victoria has about 235 to 240 hp that mean the car will get up 0-60 in 7 secends
In the gas tank.
Its in the gas tank.
The Coil On Plug ignition system uses ( 8 ) individual coils on the 8 spark plugs on your 2002 Ford Crown Victoria firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of Crown Victoria
with oil filter change - 4.7 liters ( 5.0 quarts ) of 5 W 20 ( according to the owners manual )
I usually replace fuel filter every after 35,000km and have had no problem since 2002.
According to the 2002 Ford Crown Victoria Owner Guide : Motorcraft MERCON automatic transmission fluid is used as the power steering fluid
Passanger side valve cover.