answersLogoWhite

0

Driver Side

Take out the part of the air filter housing and once you get that off you will have access

Passenger Side

You can either take out the washer fluid container or the battery and you got it

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How replace headlamps on Pontiac Sunfire 1995?

Remove the air intake splash shield from the vehicle. Remove the 2 headlamp retaining bolts. Remove the lamp assembly from the front of the vehicle. Detach the headlamp connector. Remove the headlamp bulb retaining ring. Remove the headlamp bulb from the headlamp.


How do you replace the starter on a 1995 Toyota 4Runner?

Someone has a fantastic answer on the web... http://www.yotatech.com/showthread.php?t=76358


How do you replace brakes and rotors on 2001 Toyota 4Runner?

how to replace break pads on 2001 4runner


How to replace brake fluid on 1999 4runner?

how to replace brake fluid on a 1999 Toyota 4runner


How do you replace the lowbeam headlamp on a 1995 Chevrolet 2500?

The bulbs screw in from the rear and if you can't get to the rear, you have to take the light assy off.


Put a 1991 4runner motor in a 1995 4runner?

Typically, yes. Most 1990-1995 4runner's came with the same factory 3.0 V6 engine and are interchangeable.


What would it cost to replace or repair a cracked exhaust manifold in a 1995 Toyota tacoma?

what is the cost of repair of Toyota 4runner exhaust manifold


How do you replace a blower motor on a 1995 4runner?

Check my submissions. I covered it a couple times. It is the same on 85 to 95 models. Good luck.


How do you replace a headlamp for a 2004 grand marquis gs?

how do i replace a passenger side headlamp for a 2004 grand marquis gs


How do you replace a headlamp unit on the 2004 xj series jag?

i have an xj series 2004 jaguar with a broken front headlamp, how do i replace it?


Bolt pattern for 1995 4Runner?

If your asking for the bolt pattern on the Toyota 4runner. It is a 6 on 5.5.


How do you replace the headlamps on a 95 Subaru SVX?

To replace the headlamps on a 1995 Subaru SVX, start by opening the hood and locating the headlamp assembly. Remove the retaining screws or clips holding the assembly in place, then gently pull the assembly forward. Disconnect the wiring harness from the back of the headlamp, replace the bulb by twisting it counterclockwise, and then install the new bulb by twisting it clockwise. Reconnect the wiring harness, reposition the headlamp assembly, and secure it with the screws or clips.