answersLogoWhite

0


Best Answer

Hey Sid==I think on yours, only the bulb needs changing. Just remove the light assy and change the bulbs in the rear. There are mounting screws to remove and don't unscrew the adjusting screws. Goodluck, Joe

This is a sealed beam unit. The bulb alone cannot be replaced. The entire headlight assembly needed to be replaced. First remove the screws holding the turn signal assembly, and then replace remaining screws holding the headlight. It is a bit tricky, but doable.

Just replaced both bulbs on my 98 Toyota Sienna XL. First carefully remove plug into the back of the bulb to be replaced. Do not pull the plug out by tugging on the wires, make sure you grab the plug itself. Next, remove the rubber boot protecting the back of the headlamp. You will find a metal clip clamping in the bulb. The clip is designed to be easily released. Remove the bulb and put in the replacement, without touching the glass.

I purchased my Sienna in January of 1998. Could there have been a mid-year model change that makes your van different than mine?

User Avatar

Wiki User

βˆ™ 2015-07-15 18:48:52
This answer is:
User Avatar
Study guides

Where I can purchase purchase HID Fargo ID card in Dubai

➑️
See all cards
β˜†β˜…β˜†β˜…β˜†β˜…β˜†β˜…β˜†β˜…
No Reviews

Add your answer:

Earn +20 pts
Q: How do you replace the headlight assembly located on a 1998 Toyota Sienna?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace a factory antenna on a 2002 Toyota Sienna?

"How do you replace a factory antenna on a 2002 Toyota Sienna?" I am talking about the whole assembly. Thanks


Replace water pump on Toyota Sienna?

Remove engine and transaxle assembly


How do you replace the low beam headlight located on a 1999 Toyota Sienna?

Open the hood, remove the rubber boot, unplug the wire connector, unclasp, remove the burned bulb and replace with the new one.


How do you replace the rear wheel bearing on a 1999 Sienna?

I assume that it will be like a 1998 Sienna van. There is a sealed bearing in the hub assembly and you change the whole assembly. There are four bolts that hold the hub assembly to the suspension.


How do you replace a rear wheel bearing on a 1999 Sienna?

I assume that it will be like a 1998 Sienna van. There is a sealed bearing in the hub assembly and you change the whole assembly. There are four bolts that hold the hub assembly to the suspension.


Where is the evaporator for a 98 sienna?

Its located on the passengers side inside the a/c case assembly.........


How do you Replace the headlight cover on 2004 Toyota Sienna?

hi,,does any one know how to change the 2004 sienna headlight low beam light bulb? the high beam can be open turn it counterclockwise,,but can't open on the low beam,


Where is the Fuse for headlight in Toyota Sienna 2000?

The fuses for 2000 Toyota Sienna is located in the engine compartment. The fuses are labeled as slot 12 and 13 and are rated at 15 amps.


Can you buy the brackets that hold the headlight-turn signal assembly to a 2001 Toyota Sienna?

yes, try a junk yard before going to a Toyota dealer


Where is the Toyota sienna fuel filter 2008 located and need to replace it?

In the fuel tank.


Where is the city Sienna located in?

Sienna is located in the country Egypt.


How do you replace a starter in a 2000 Toyota Sienna?

How to replace a starter in a 2009 toyota sienna

People also asked