Mazda 626
Mazda MX-6

How do you replace the headlight bulb located on a 1999 Mazda 626?


Top Answer
User Avatar
Wiki User
2008-06-01 00:35:00
2008-06-01 00:35:00

I followed the procedure for the 1998 model in an earlier post and it was exactly the same. Just remember to handle the new bulb by the base when installing to keep oil from fingers off of the glass. First I removed the two bolts that hold the intake in place. Then I moved the intake off to the side. Then you have to pull back the rubber hood from the light. After that I used a pair of pliers to unhook a clip that holds the bulb in the mount. Dudeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeee you were right!!

For the right side you have to remove two screws and move the coolant reservoir via Phillips head screwdriver. You can reach the left side without removing anything. You will need plenty of lighting to see what you're doing.

User Avatar

Related Questions

how do replace the thermostat on a 1999 mazda b2500 truck?

How do you replace a 1999 Ford Escort headlight - could use a picture.

Where is the fuel injector located on a 1999 mazda 626v6

How do you replace a 1999 Ford Escort headlight bulb?"

Where is the thermostat located on a 1999 Mazda 626?

There are bolts surrounding the headlamp. remove these and the wires.

With another Headlight Assembly that is made for a 1999 Dodge Durango.

To replace a headlight switch on a 1999 Ford Escort, look under the hood. Right behind the headlight, twist the bolts to remove old switch and replace with new one.

1999-2000 Mazda Miata headlight bulb replacementIts a Halogen bulb so you dont replace the whole headlight assembly, just the bulb.From engine compartment, unplug the bulb connector on bad bulbRemove the rubber ring covering the area by pulling on the tabs.Remove the bulb by depressing the spring clip and swinging it out, similar to a safety pin.Remove the halagon bulb, careful not to touch the surface of the new bulb with your fingers.Replace in reverse order.

Where is the flasher relay on the 1999 mazda protege

i need a diagram to show me how to remove a starter on millenia s 1999 mazda

take the complete headlight assembly loose or out to get to the bulb.

where is the thermostat located in a 1999 Toyota Camry located and how do you replace it.

lift hood,on top of the headlights are tabs to pull up.pull the tabs up and pull the headlight towards you and it will make the bulb holders visible

Replace control unit located under dash usually in the middle section

On a 1999 C5 corvette manually put the flip up headlight in the up position, remove the plastic headlight trim around the headlight with three screws... put your bare arm under the raised headlight and remove the turn signal bulb with a careful twist.

99 mazda b3000 where is the speed sensor located

There aren't headlight covers, it all one unit. One of my lens was cracked and I had to replace the whole unit.

Remove the retaining screws from the headlight assembly. Remove the wiring harness from the back of the headlight. The headlight will come out. Reverse the process to install the new headlight.

follow the bottom radiator hose up to the engine and remove the two bolts an you should see it

Open the hood, remove the rubber boot, unplug the wire connector, unclasp, remove the burned bulb and replace with the new one.

To replace the headlight bulb on a 1999 Porsche Boxster you will need to open the trunk and take out the screw of the spare tire compartment. Slide the entire headlight assembly out after loosening it with a hex socket wrench. Then, put a new bulb in place.

The 1999 Mazda 626 alternator is located on the right hand side of the engine. The alternator will be near the front of the engine.

The only fuel filter on the 1999 Protege is a "sock" on the fuel pump pickup tube inside the gas tank. The sock can't be replaced seperately from Mazda, you have to replace the fuel pump which does not include the sending unit.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.