You need to remove the windshield wiper fluid and radiator over flow tank if it is on the passenger side to do that you need to disconnect the over flow tube from the radiator and then there are 2 connectors holding the tanks in they are black with a circle thing on top using a screwdriver lift the black circles up they come up about an inch then the rest just easily pulls up lift the tanks straight up (it will be a little tight) there is still a plug connected so you can either unplug it or just set the tanks on the engine and at this point you should be able to reach in and change the bulbs..good luck .. i just done mine and wasn't hard at all.
The headlight assembly is on a mounting bracket which is fastened to the frame. By removing the assy you can get access to both headlamps without disrupting the aiming mechanism. Use a 10mm nut driver or ratchet to remove 4 screws per assy. Two from front, one from the top corner that holds the fake side marker lens, and one from behind the side marker you just removed. This gives you access to both head lamps. This was for a 2003 Astro.
Wiki User
∙ 2015-04-22 17:09:23read the manual
Remove the headlight connector from the back of your 2002 Chevy Monte Carlo headlight. Take hold of the lightbulb, push in and turn at the same time, to remove. Reverse the process to replace the new headlight.
How do i change the window on a 95 chevy astro van
can I get a diagram to replace vacuum hoses ona 986 chevy astro van
There are two clips on the wall that holds the headlights. Push the clips away and pull the headlight housing out.
how to replace a center link on Chevy astro van 1994 suspension
Nothing, it's discontinued.
more then likely w/ no more info then is provided there is a silver rod on top of the headlight pod you slide to the side then the whole light will come out and you can replace the bulb and reinstall.
the headlight assembly needs to come out in order to replace the bulb.
The headlight fuse located on a 1995 Chevy Tahoe is under the hood. It is located in the fuse box on the passenger side.
It is built into the headlight switch.
Open the hood, remove the two locks that hold the headlight assembly in place, with the two locks removed you can wiggle the headlight assembly out and gain access to the back side of the assembly to remove and replace the headlight bulb.