Headlights Tail and Brake Lights
Jaguar auto
Pontiac Grand Am
Ford F-150

How do you replace the headlight bulb located on a 2002 Jaguar X-Type 30?

515253

Top Answer
User Avatar
Wiki User
Answered
2006-02-22 05:30:25
2006-02-22 05:30:25

Best done cold. from under the hood, there are to metal clamps on the back of the headlamp assembly and remove the cover then replave the bulb, on the driver side you can remove the battery for ease

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


how do you remove and replace rear bumper on an xtype jag

my jaguar xtype is beeping, and now my brake lights don't work when my headlights are on. Do I need to replace a fuse or reset the rear sensor? Thanks Jasmin-

2004 xtype takes a 2035 battery,can i use the 2032 battery?

THe Jaguar XType has the best safety rating. It got 4 out of 5 stars on the crash rating. It has side airbag curtains and active head restraints and airbag occupancy sensors.

It is rich or lean bank 1 or 2 i am not sure which one it is but i know it is rich or lean code they have the same codes as ford.

rough running, water or emulsion in oil, oil or emulsion in water (floating on water in top of radiator), steam from exhaust, compression test to check.

malcom xType your answer here...

its in the glove box you have to open a little hatch first and a torch will help ,its a bit dark You can find pictures and details here:- http://www.brendastuart.co.uk/xtype/blue_spring/ you may need to cut and paste the address into your browser i have a 2002 x-type and mine is under the steering wheel to the left side

Possible, but very, very, very bad idea:#include #include typedef struct test {xtype x;char y;} test;printf ("sizeof (xtype)=%d\n", (int)offsetof (test, y))

Check plugWhat type do you have? On the X-type- fill plug is a rubber plug on top of the tranny. The check is-remove the Allen plug about 6-8 inches from the fill plug, add till fluid flows out. Engine must be on. I have a new style s type. Any idea how to check this?Where is the Allen plug located from the fill plug? Underneath trans, side or top? We have a 2002 all wheel drive automatic transmission Xtype.

That is bad lucksince your handel broke and the remote doesn't work you have to either fix a new handle or change the remote, don't u have a spare remote?

Attach a brake bleeder tube to the bleeder valve, loosen but dont remove caliper mounting bolts. with the old inboard disc pad still installed and the outer disc pad removed use a large "C" clamp to apply pressure while bleeding the brake fluid. This allows the cylinder to retract into the caliper without allowing air to enter the system. Also a reminder, As you know the caliper assembly is a little heavy and you'll want to support its weight so it is not "hanging" by its expensive hydralic brake line (hose). a metal coat hanger tied to the coil spring and run through the caliper mounting hole works well.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.