Ok just done it (well mine is a 2003 Chrysler Voyager - but I guess its the same vehicle).These are the instructions for the LH lamp.
# Open up the bonnet, and look at the areas above the headlamp and in front of the battery. # You should be able to locate 3 hex headed bolts, with screw slots (so you can turn them with a spanner or a flat blade screw driver). They are about 8mm in diameter. Oh 8mm is about 1/4 inch.
# Undo all three completely and place somewhere safe, the headlamp unit will become loose. # Prise it out gently so as not to damage it. # On the back of the headlamp you'll see a number of plastic push fit "Tupperware" covers. Pull the one of behind the bulb that you need to replace and the back of the bulb is revealed. # Easy! # Reassembly is he reverse process. Now if anyone can tell me how to get my lamps to point to the opposite side of the road (my car is set up for right hand driving in the UK but I drive on the continent allot)...
Need to know which engine you have.
Its located on the side of the transmission, real simple to replace.
A Plymouth Voyager does not have a maf sensor.
how do you replace the camshaft position sensor on a 1997 plymouth voyager 3l
belt assembly for a 95 Plymouth voyager
I have not received an answer to my question, "How do you replace a heater core in a 1995 Plymouth Voyager SE? When can I expect an answer? Thank you!!! nellkat60
A 1993 Plymouth Voyager does not have a cabin filter.
Check out the related link for instructions on how to change the fuel filter in a 1999 Plymouth Voyager.
take it in
1st; buy a new thermostat
I have a 91, it was real simple. Lift the hood and reach in right behind the front light, you will see where there is a cord attached to the light bulb, disconnect it. Untwist the circular ring and the bulb pulls right out. Replace bulb and backtrack to put back together.
Its held in with 4 star shaped screws... just disconnect the headlight bulbs, remove the screws and install the same way that you took that out with.
Try this URL; http://www.autozone.com/servlet/UiBroker?ForwardPage=az/cds/en_us/0900823d/80/10/cb/1f/0900823d8010cb1f.jsp
The thermostat housing for the 99 Voyager is located on the top of the motor, follow the top radiator hose to the engine,there you will find the housing ( lefthand side) undo the bolts and remove, remember to replace the gasget as well, then just reassemble the same as you removed it. Darlene
It is located behind the timing belt. Timing belt must be removed to access the pump. Replace timing belt.
how do you replace headlight bulb in a 2001 celica gts
The panel is broken. Replace it
is there a way to fix or replace just the rubber in the mount
it will be around $400 plus parts
Answerfuel filter is located directly on the fuel tank. must drop tank to access the quick connect lines.Thank you ,you are very helpfull,good luck.
Remove the wiring harness from your 1992 Plymouth Grand Voyager alternator. Remove the alternator belt. Remove the alternator retaining bolts. Reverse the process to install your new alternator.
Take out the headlight is the easiest way!
You should be able to get at the mounts from the inside of the rear fender
Not an easy job. Get a manual on your car from AUTOBOOKSONLINE.COM.
This is not an easy job. Get a manual on your car and it will help on the next repair.