First you buy the correct replacement bulb. The low beam or High beam - H11 or H9, then with gloves or Very carefully with out touching the bulb with your naturally oily fingers you remove it from the packaging. Next on the car remove the wiring harness from the original bulb, then with a simple half twist you pull it out from the back of the headlamp housing. Connect the new bulb with the wiring and twist it into position. Done. Same if you have the optional HID's, but more expensive and delicate bulbs are involved. Do not leave the Head lamp housing without a bulb attached for fear of moisture and or dirt entering.
To get access to the rear of the headlamp housing is the more difficult part. U jack the car up and twist the wheel to one side to get access to the inner wheel well. Remove the pins holding the inner liner and then you should have access. Messy yes, but doable if one has time and patience to do it safely. Car jacks have been known to slip on occasion.
go to back of headlight assembly and twist it out.
The headlight adjustment screws on a 2001 Nissan Altima are located on the sides and back of the headlight assembly. They allow for small changes to be made to the position of the beams.
yes
how do you replace the ac evaportator
how to replace an altinator in a 2005 nissan altima
It is located on the backside of the engine. Go to youtube and type in how to replace camshaft sensor on 2005 Nissan altima and it will show where it is and how to replace it, that is how I did my one.
One headlight not working
You will need at least $300 to replace a radiator in Nissan Altima.
How do you replace a water pump on a 98 nissan altima?
I need to replace the back window of a 1999 Nissan Altima how do I do this
My headlight is not working on the passengers side. Do I need to change out the headlight assembly or can I simply change out the bulb? My headlight is not working on the passengers side. Do I need to change out the headlight assembly or can I simply change out the bulb?
My daughter has a 2002, and you must take it to the dealer, so we were told.