answersLogoWhite

0


Best Answer

The headlight adjustment screws on a 2001 Nissan Altima are located on the sides and back of the headlight assembly. They allow for small changes to be made to the position of the beams.

User Avatar

Wiki User

9y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where are the headlight adjustment screws on a 2001 Nissan Altima?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do I adjust a Laguna headlight?

You can adjusts the headlight by turning the headlight adjustment screws. The adjustment screws are on each side of the headlight.


How do you adjust the headlights on a 1998 Toyota Sienna?

The 1998 Toyota headlight have two adjustment screws. There is an adjustment screw on the top and bottom of the headlight. Turn the screws to adjust the headlight.


How do you adjust headlight 2001 corolla?

Each headlight has two adjusting screws. The adjusting screws are on the top and bottom of the headlight. Adjusts the headlight by turning the adjustment screws.


Where are the headlight adjustment screws located on a 1997 Ford ranger?

The headlight adjusting screws are accessible from the rear of the headlight, you have to open the hood to access them.


Where is the vertical headlight adjustment screw on a 2002 cavalier?

The headlight adjustment screws are found in 2 holes behind each headlight, through the air shield. They are gold star shaped bolts.


Where are the headlight adjustment screws on a 1988 Ford Mustang?

the headlight adjustment screws on a 1987-1993 ford mustang are behind the headlights in the engine compartment. there is a radiator core support directly behind the headlights, between the headlamp and the core support is where the adjustment screws will be found. They are very small (4MM) hex head adjusters.


Where are the vertical headlight adjustment screws on a 1999 Honda Civic EX?

The vertical adjustment screws are accessed at an angle near the center of the headlight in the engine compartment. Point a light from the inner edge of the headlight toward the back center of the light and you will see a toothed wheel. Turn this with a Phillips screwdriver to raise or lower the headlight.


How do you aim headlights on 2002 Acura?

The are adjustment screws next to the headlight housings. To adjust the headlights either loosen or tight the screws. This will either raise or lower the headlight unit.


How do you adjust the headlights on a 1979 Chevy Corvette?

There are two adjustment screws on each headlamp. One on the top for verical adjustment and one on the side for horizontal adjustment. These are different than the screws holding on the chrome headlight rings.


How do you replace the headlight bulb located on a 1986 Honda Prelude?

You need to replace the entire headlight. Only remove the screws that hold the trim in place. Don't back out the adjustment screws.


How to change a 96 Camero headlight?

remove the torx head retaining screws and remove the bezel. remove retainer screws but dont touch the adjustment screws and pull out headlight then unplug . replace light, plug it in and secure it. then replace bezel and its retaining screws.


How do you remove the headlight in a 1989 Honda accord?

On retractable headlight models raise the headlightsDisconnect the neagative battery cableRemove the retaining screws taking care not to disturb the adjustment screwsRemove the retainer and pull the headlight out enough to allow the connector to be unplugedRemove the headlightTo install the headlight plug the connector in place the headlight in position and install the retainer screws tighten the screws securleyPlace the headlight bezel in position and install the retaining screws