answersLogoWhite

0


Best Answer

To replace the heater blower cable on a 1988 Ford F-150, first remove the driver's seat. Then, remove console side panels, glove box, and radio. Pull of AC control knob and detach console from the?æfront frame at its corners. Next, remove console side braces, right vent distribution, steering column cover and left vent distribution. Finally, remove the 10 clips holding the heater blower cable and replace.?æ?æ?æ

User Avatar

Wiki User

9y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace the heater blower cable on a 1988 Ford F-150?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace a heater on a 1988 Honda?

A "heater" or a "heater core"?


Where is the blower motor located on a 1988 Chevy Celebrity eurosport?

If you are asking about the heater blower motor it is mounted to the heater ducting in the engine compartment on the passenger side.


How do you replace a broken throttle cable on a 1988 Ford Ranger?

how do i replace a throttle cable on a 1988 ford ranger pickup


Exactly where is heater blower resister on 1988 Ford Laser?

I found the resister, it is a small module held by 2 small screws on the base of the heater blower behind the glove box.


Where is heater core on 1988 Buick Electra 307?

The heater core is mounted to the passenger side firewall on the 1988 Buick Electra 307. The blower motor needs to be removed to access the heater core.


How do i replace a speedometer cable on a 1988 ford ranger 4wd with a 2.9 engine?

You can replace the speedometer cable, on your 1988 Ford Ranger, by loosening the cable nut on each end of the cable. The cable will come off and can then be replaced.


How do you find a blower motor resistor in a 1988 ford van?

The blower resistor is usually found attached to the A/C-heater box under the hood.


Where is the heater relay on 1988 Chevy Celebrity?

There is a fuse for the blower motor on the fuse panel, I do not know of a relay.


How do you fix your no heat situation on a 1988 Dodge 600 SE Turbo?

Thermostat may be stuck open. Drain the system, replace the thermostat and fill with a 50/50 mix of the correct antifreeze and distilled water. Heater core may be clogged. Replace the heater core. Blend door be stuck. Blower motor may not be running. Repair the problem. Blower motor not working. Either the blower motor is defective, fuse is blown, or the resistor pace is defective.


1988 Dakota heater core replacement?

To replace a 1988 Dakota heater core, first discharge the A/C. Then remove the lower instrument panel before removing the heater box unit.


How do you fix 1988 S10 emergency brake cable?

Really ain't no fixing a brake cable. Replace it with a new cable.


Why no air flow from heater when the blower motor works on a 1988 Delta 88 Oldsmobile?

Probably the heater core, it is a beast of a job to do, but is gratifying to say the least. If the is a smell of antifreeze you can almost bet it is the heater core.