I figured since nobody else had an answer for this I would elaborate. Disconnect negative battery cable, Remove Steering wheel, Turn signal stick, and bezels from lower instrument panel. Remove turn signal switch. Now it gets tricky. Use button release to remove key tumbler. Remove three screws and remove key tumbler housing. Pull the two pins on sides of column. Release Tilt wheel latch at bottom. Unbolt steering shaft from U-joint at engine side of firewall. Pull out on now released part of steering column. Only as much as you need! You can now remove and insert your ignition actuator. I'm sure this would be easier with pictures. Hopefully if your having trouble this will give you an idea of what to do.
How do I locate the heater blend door actuator in a Ford f150 pickup
key does not start the truck and will not come all the way back to lock.
take off the distributor cap see what you find.
We are replacing the ignition switch on a 1976 ford F150 Need some help - give us directions
get a person who does that work to come over
I believe it is located behind the glove compartment. Drop out the glove compartment box and you will see the blend door actuator.
yes it does
How do I replace the block heater in my 1998 F150 4.6L?
f150 ignition coil sequence
No
Answerchange your 4x4 actuator It could be that or in the switch. But probable it is the actuator on trans mission..
Answerchange your 4x4 actuator It could be that or in the switch. But probable it is the actuator on trans mission..