If you mean the STX 38, the ignition coil is underneath the top engine cover. First you must remove the circular screen cover on top of the engine. Remove the three small bolts inside the center cup and then remove the bolts holding down the outer ring. The outer ring and screen should lift right off with little effort. Then remove the bolts on the top-side portion of the engine cover (there are about 7 or 8 of them going around the engine) -one of them holds the oil dipstick tube in place. 3 of them bolt the cover directly down to the engine block. Once all of those are out, the engine shroud (cover) lifts right off and there, in the center of the motor is the ignition coil held down by 2 bolts. A single wire feeds the coil and the spark plug wire exits the coil. Remove the feed wire, remove the plug wire from the plug, unfasten and remove the old coil and replace. Reinstall the cover and upper screen assembly and you're all done. You'll need a 1/4 drive socket set and that's pretty much it. If you take your time, you should be done in 30 minuts or so.
Best Regards,
Bob Lituri
lituri54@aol.com
BTW, the gap should be set at 0.010" between the ignition module (coil) and flywheel.
More than likely it is a bad ignition coil.
http://www.ehow.com/how_4509339_replace-ignition-coil-pack-ford.html
Ignition what? Switch? Coil?
Replace the ignition coil(s).
Replace it only if it becomes defective.
Spark plug shot or gap not correct. Replace plug and if still doesn't work check and replace coil if bad. Check you tube for how to check col check coil.
there is a coil on each plug
pull the two bolts buy new or used ignition coil the replace the ignition coil is on th left side of motor right by the tbi
Replace the ignition coil.
Replace high tension coil wire. Probably time to replace all the spark plug wires.
Lt133 lawn tractor will not fire is coil bad
you have to replace your spark plug wires there is a coil on each wire for each cylinder.