0
How do you replace the ignition lock cylinder on your 1993 Ford Festiva?
Wiki User
∙ 12y ago
remove the two screws holding face plate in center of steering wheel and remove plate. next remove large nut in center. Using a steering wheel puller remove steering wheel. next there is a pin next tothe lock cylinder. that will have to be driven inwith a hammer and a punch. lock cylinder should be able to be pulled out. installation is the reverse of removal.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Replace ignition switch for 1993 Buick century?
Replace ignition switch for 1993 buick century?
How do you replace cv joints on a 1993 Ford Festiva?
It is best to replace the whole axle, Its easy to do not to mention pretty inexpensive....
Where is the brake fluid reservoir on a 1993 Ford Festiva?
Drivers side. Near firewall, on top. Cylinder with a black lid.
Are ignition switch and lock cylinder 2 different parts on 1993 Dodge Dakota?
Yes. The lock cylinder is metal part that the key goes into. The ignition switch houses the lock cylinder.
How to replace ignition switch on 1993 buick regal?
I believe that the switch is located in the ignition cylinder (which you can get from any auto parts store). Unfortunately you'll need a steering wheel puller and a tilt removal mechanism before you can start with that.
Where is the Jeep Wrangler slave cylinder?
how to replace the slave cylinder on a 1993 jeep wrangler
What is the exact location of the ignition control module on a 1993 Ford Festiva?
Here is a page from google i visited about the module in question. http://www.ncf.ca/~ag384/IgnitionModule.htm
How do you know if the Ignition Switch has gone bad on a 1993 Dodge Shadow?
turn key inside the ignition and see whether the warning lights, ie check engine light and others dim as the key is being turned. If they don't dim then it is the ignition lock cylinder which is fairly easy to replace.
Where is the ignition module on a 1993 Ford Probe 4 cylinder?
In the dist. Takeit to Auto zone and have them check it out.
What causes a 1993 Ford Festiva to sputter when on acceleration only when going forward and not backward?
If a car sputters when it accelerates there may be a problem with the ignition. Another option is that the timing belt is malfunctioning.
Do you need to replace the whole ignition lock assembly when the electrical portion of the ignition switch goes bad in a 1993 Honda Civic LX Auto Trans?
If the lock cylinder is faulty, the entire steering column lock assembly will have to be replaced. reference " Haynes Repair Manual"
How do you replace the ignition switch on your 1993 Chevy K 2500?
Remove the retaining ring at the top of your 1993 Chevrolet K 2500 ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
